The John Deere 2941 is 62 in wide, with a 101.6 in wheelbase.
Width62 in (5 ft 2 in) / 1,574.8 mm
Wheelbase101.6 in (8 ft 5.6 in) / 2,580.6 mm
John Deere 2941 Dimensions
Overall width
62 in (5 ft 2 in) / 1,574.8 mm
Wheelbase
101.6 in (8 ft 5.6 in) / 2,580.6 mm
Front tread width
62 in (5 ft 2 in) / 1,574.8 mm
Rear tread width
62 in (5 ft 2 in) / 1,574.8 mm
Tractor Size Comparison Chart
Overall width comparison
This model
62 in
Average
64.6 in
Low
20 in
High
144 in
Wheelbase comparison
This model
101.6 in
Average
79.2 in
Low
34.8 in
High
190.5 in
John Deere 2941 Extra Dimension Notes
Fitment note
The John Deere 2941 size data gives width at 62 in (5 ft 2 in) / 1,574.8 mm. Add margin for cab roof, loader arms, mirrors and wheel equipment.
Wheelbase note
The John Deere 2941 lists wheelbase at 101.6 in (8 ft 5.6 in) / 2,580.6 mm. Use it when comparing size against tractors that look similar on paper.
Tread width note
The John Deere 2941 shows 62 in (5 ft 2 in) / 1,574.8 mm at the front and 62 in (5 ft 2 in) / 1,574.8 mm at the rear for tread width. That is the wheel-stance side of the dimension table.
Storage Tips
Big tractors need service room around them, not just enough space to squeeze inside.
A 101.6 in wheelbase means the approach into the storage bay matters, not just the doorway width.
Storage FAQ
Will it fit in a garage?
A tight garage is a bad match when the machine is 62 in wide and 101.6 in wheelbase. The John Deere 2941 needs a clear opening and bay closer to 10 ft wide for comfortable storage.
What size door should I check?
A bare fit only says the tractor can squeeze through. For normal use, the John Deere 2941’s height not captured height and 62 in width point to about the tractor height plus clearance high and 10 ft wide, with the tractor length plus attachment room depth.
Do attachments change the storage size?
Yes. If the bay only clears the listed length not captured length, it is too short once attachments stay on. Use about the tractor length plus attachment room bare, then add attachment length.
How much maneuvering room should I allow?
The length not captured length needs bay depth, but the 101.6 in wheelbase needs lineup room. Treat about 20 ft outside the shed as the practical approach zone.
Official information note
Mistakes do happen. Tractor dimensions can change by year, tire setup, cab/ROPS setup, attachments and market. Please check the operator manual, build sheet and official deere.com website for official information.
