For the John Deere 332, coolant capacity is 0.74 gal (2.8 L). Coolant choice is listed as John Deere Cool-Gard II, with 40/60 coolant and water mix guidance.
John Deere 332 Coolant Capacity Specs
| Coolant capacity | 0.74 gal (2.8 L) |
|---|---|
| Coolant type | John Deere Cool-Gard II |
| Antifreeze mix | 40/60 coolant and water mix |
| Engine model | Yanmar 3TN66UJ |
| Engine horsepower | 16 hp |
| Engine displacement | 40.2 cu in (0.66 L) |
John Deere 332 Coolant Capacity Guide
Coolant capacity guide
Compared with a broad older small tractor guide, not the full tractor dataset.
John Deere 332 Coolant Service Notes
| Coolant capacity note | The useful service number here is 0.74 gal (2.8 L). Keep some extra coolant available because trapped air can lower the level after the first warm-up |
|---|---|
| Coolant service note | For a full coolant service on the John Deere 332, plan around 0.74 gal (2.8 L) and match the listed coolant guidance: John Deere Cool-Gard II and 40/60 coolant and water mix |
| Coolant type note | The John Deere 332 coolant type is John Deere Cool-Gard II. Wrong coolant chemistry can reduce corrosion, freeze and boil protection |
| Antifreeze mix note | The listed mix for the John Deere 332 is 40/60 coolant and water mix. Keep the coolant strength in range after a drain, flush or top-up |
| Refill check | After a drain and refill on the John Deere 332, the cooling system can burp air. Recheck the level after the first warm-up and cool-down cycle |
| Engine context | The engine context for the John Deere 332 is engine model Yanmar 3TN66UJ, engine horsepower 16 hp, and engine displacement 40.2 cu in (0.66 L). Use this for comparison only; the refill amount is the coolant capacity above |
John Deere 332 Coolant Capacity FAQ
How much coolant should I buy for the John Deere 332?
The cooling system capacity for the John Deere 332 is 0.74 gal (2.8 L). This is the main refill figure for a drain, flush or coolant change
Is John Deere Cool-Gard II listed for the John Deere 332?
For the John Deere 332, the coolant type is listed as John Deere Cool-Gard II. Avoid mixing incompatible coolant products
What mix ratio should I use when refilling the John Deere 332?
For the John Deere 332, the coolant mix is listed as 40/60 coolant and water mix. Do not dilute the system with too much plain water
Do I fill the John Deere 332 exactly to capacity or check the level marks?
Fill the John Deere 332 slowly, run it with the heater/thermostat cycle where applicable, let it cool and check the level again. That helps catch trapped air
Can I just add coolant to the John Deere 332 if the level is low?
Flush the John Deere 332 cooling system if the coolant is dirty, contaminated, badly diluted or overdue for service. A simple top-up does not fix old coolant chemistry
Mistakes do happen. Tractor coolant capacity and coolant type can change by year, market, engine, radiator setup and service procedure. Check the operator manual, service manual and official deere.com website before draining, flushing or refilling the cooling system.
