John Deere 755 Coolant Capacity

Quick answer:

The John Deere 755 coolant capacity is 1 gal (4 L). The listed coolant is John Deere Cool-Gard II, with 40/60 coolant and water mix guidance.

Coolant capacity1 gal (4 L)Cooling system refill amount
Coolant typeJohn Deere Cool-Gard IIMatch coolant chemistry
Antifreeze mix40/60 coolant and water mixFreeze/boil protection

John Deere 755 Coolant Capacity Specs

Coolant capacity 1 gal (4 L)
Coolant type John Deere Cool-Gard II
Antifreeze mix 40/60 coolant and water mix

John Deere 755 Coolant Capacity Guide

Coolant capacity guide

This model

1 gal

Class low

0.8 gal

Class typical

2.5 gal

Class high

5 gal

Compared with a broad older small tractor guide, not the full tractor dataset.

John Deere 755 Coolant Service Notes

Coolant capacity note The John Deere 755 cooling system is listed at 1 gal (4 L). Final level can settle after the first heat cycle, so recheck the level after service
Coolant service note Use 1 gal (4 L) as the refill amount for the John Deere 755, but do not mix coolant types blindly. The listed coolant detail is John Deere Cool-Gard II and 40/60 coolant and water mix
Coolant type note The listed coolant type for the John Deere 755 is John Deere Cool-Gard II. Match the coolant chemistry before topping up or flushing the system
Antifreeze mix note The listed antifreeze mix for the John Deere 755 is 40/60 coolant and water mix. Mix ratio affects freeze protection, boil protection and corrosion control
Refill check When refilling the John Deere 755, do not pour in 1 gal (4 L) and walk away. Fill slowly, run the engine, let it cool and recheck the level

John Deere 755 Coolant Capacity FAQ

What is the refill amount for the John Deere 755 cooling system?

A full coolant refill on the John Deere 755 is listed at 1 gal (4 L). Fill slowly and allow for a small top-up after the first heat cycle

What should I match when topping up coolant in the John Deere 755?

The John Deere 755 coolant listing shows John Deere Cool-Gard II. Use the operator manual and coolant label to confirm compatibility

How should coolant concentrate be mixed for the John Deere 755?

The John Deere 755 uses 40/60 coolant and water mix where that mix is specified. Confirm the mix against your climate and manual

Should I run the John Deere 755 after adding coolant?

Check the John Deere 755 coolant level cold after service. Hot coolant is pressurized and dangerous, so let the system cool before opening the cap

When is a full coolant flush better than a top-up on the John Deere 755?

If coolant condition is good, topping up may be enough. If it is old or contaminated, a full drain and refill is safer for the John Deere 755

Official information note

Mistakes do happen. Tractor coolant capacity and coolant type can change by year, market, engine, radiator setup and service procedure. Check the operator manual, service manual and official deere.com website before draining, flushing or refilling the cooling system.