Antifreeze mix40/60 coolant and water mixFreeze/boil protection
John Deere 6210SE Coolant Capacity Specs
Coolant capacity
3.57 gal (13.5 L)
Coolant type
John Deere Cool-Gard II
Antifreeze mix
40/60 coolant and water mix
Engine horsepower
90 hp
Engine displacement
276.4 cu in (4.53 L)
John Deere 6210SE Coolant Capacity Guide
Coolant capacity guide
This model
3.57 gal
Class low
6 gal
Class typical
9.5 gal
Class high
14 gal
Compared with a broad 6 series guide, not the full tractor dataset.
John Deere 6210SE Coolant Service Notes
Coolant capacity note
The John Deere 6210SE coolant capacity is 3.57 gal (13.5 L). Treat it as a cooling-system amount, not a radiator-only top-up amount
Coolant service note
Use 3.57 gal (13.5 L) as the refill amount for the John Deere 6210SE, but do not mix coolant types blindly. The listed coolant detail is John Deere Cool-Gard II and 40/60 coolant and water mix
Coolant type note
The listed coolant type for the John Deere 6210SE is John Deere Cool-Gard II. Match the coolant chemistry before topping up or flushing the system
Antifreeze mix note
The listed antifreeze mix for the John Deere 6210SE is 40/60 coolant and water mix. Mix ratio affects freeze protection, boil protection and corrosion control
Refill check
When refilling the John Deere 6210SE, do not pour in 3.57 gal (13.5 L) and walk away. Fill slowly, run the engine, let it cool and recheck the level
Engine context
The engine context for the John Deere 6210SE is engine horsepower 90 hp and engine displacement 276.4 cu in (4.53 L). Use this for comparison only; the refill amount is the coolant capacity above
John Deere 6210SE Coolant Capacity FAQ
What coolant amount is listed for the John Deere 6210SE?
A full coolant refill on the John Deere 6210SE is listed at 3.57 gal (13.5 L). Fill slowly and allow for a small top-up after the first heat cycle
What coolant type does the John Deere 6210SE use?
The John Deere 6210SE coolant listing shows John Deere Cool-Gard II. Use the operator manual and coolant label to confirm compatibility
How should coolant concentrate be mixed for the John Deere 6210SE?
The John Deere 6210SE coolant mix guidance is 40/60 coolant and water mix. Keep the mix consistent when topping up so freeze and boil protection stay in range
What is the final check after a John Deere 6210SE coolant change?
Check the John Deere 6210SE coolant level cold after service. Hot coolant is pressurized and dangerous, so let the system cool before opening the cap
Should I drain and refill the John Deere 6210SE coolant system?
If coolant condition is good, topping up may be enough. If it is old or contaminated, a full drain and refill is safer for the John Deere 6210SE
Official information note
Mistakes do happen. Tractor coolant capacity and coolant type can change by year, market, engine, radiator setup and service procedure. Check the operator manual, service manual and official deere.com website before draining, flushing or refilling the cooling system.
