For the John Deere 62, coolant capacity is 14 gal (53 L). Coolant choice is listed as John Deere Cool-Gard II, with The recommended coolant for John Deere tractors, including the 62 model, is John Deere guidance.
Coolant capacity14 gal (53 L)Cooling system refill amount
Antifreeze mixThe recommended coolant for John Deere tractors, including the 62 model, is John DeereFreeze/boil protection
John Deere 62 Coolant Capacity Specs
Coolant capacity
14 gal (53 L)
Coolant type
John Deere Cool-Gard II
Antifreeze mix
The recommended coolant for John Deere tractors, including the 62 model, is John Deere
Engine horsepower
10.1 hp
Engine displacement
0.9 L (54.9 cu in)
John Deere 62 Coolant Capacity Guide
Coolant capacity guide
This model
14 gal
Class low
0.8 gal
Class typical
2.5 gal
Class high
5 gal
Compared with a broad older small tractor guide, not the full tractor dataset.
John Deere 62 Coolant Service Notes
Coolant capacity note
The main coolant number for the John Deere 62 is 14 gal (53 L). Use it as the cooling-system refill amount, then check the radiator or overflow level after the engine has warmed up and cooled down
Coolant service note
For a full coolant service on the John Deere 62, plan around 14 gal (53 L) and match the listed coolant guidance: John Deere Cool-Gard II and The recommended coolant for John Deere tractors, including the 62 model, is John Deere
Coolant type note
The John Deere 62 coolant type is John Deere Cool-Gard II. Wrong coolant chemistry can reduce corrosion, freeze and boil protection
Antifreeze mix note
The listed mix for the John Deere 62 is The recommended coolant for John Deere tractors, including the 62 model, is John Deere. Keep the coolant strength in range after a drain, flush or top-up
Refill check
After a drain and refill on the John Deere 62, the cooling system can burp air. Recheck the level after the first warm-up and cool-down cycle
Engine context
The engine context for the John Deere 62 is engine horsepower 10.1 hp and engine displacement 0.9 L (54.9 cu in). Use this for comparison only; the refill amount is the coolant capacity above
John Deere 62 Coolant Capacity FAQ
What is the full coolant refill capacity for the John Deere 62?
The cooling system capacity for the John Deere 62 is 14 gal (53 L). This is the main refill figure for a drain, flush or coolant change
What coolant should I put in the John Deere 62?
For the John Deere 62, the coolant type is listed as John Deere Cool-Gard II. Avoid mixing incompatible coolant products
What mix ratio should I use when refilling the John Deere 62?
The John Deere 62 antifreeze guidance is The recommended coolant for John Deere tractors, including the 62 model, is John Deere. Check the coolant label before mixing concentrate and water
Should the John Deere 62 coolant be checked hot or cold?
Fill the John Deere 62 slowly, run it with the heater/thermostat cycle where applicable, let it cool and check the level again. That helps catch trapped air
What signs mean the John Deere 62 coolant should be flushed?
Flush the John Deere 62 cooling system if the coolant is dirty, contaminated, badly diluted or overdue for service. A simple top-up does not fix old coolant chemistry
Official information note
Mistakes do happen. Tractor coolant capacity and coolant type can change by year, market, engine, radiator setup and service procedure. Check the operator manual, service manual and official deere.com website before draining, flushing or refilling the cooling system.
