The John Deere 5215 tractor hydraulic pump flow is 10.9 GPM, and hydraulic system pressure is 1,900 psi.
Hydraulic pump flow10.9 GPM
Implement flow10.9 GPM
Total hydraulic flow10.9 GPM
Hydraulic pressure1,900 psi
Hydraulic system typeclosed-center
Hydraulic fluid capacity10 gal
John Deere 5215 Hydraulic Flow Details
Hydraulic pump flow
10.9 GPM
Implement hydraulic flow
10.9 GPM
Total hydraulic flow
10.9 GPM
Hydraulic system pressure
1,900 psi
Hydraulic system type
closed-center
Hydraulic fluid capacity
10 gal
Hydraulic Flow Comparison Chart
Hydraulic pump flow comparison
This model
10.9 GPM
Average
22 GPM
Low
5.3 GPM
High
59 GPM
Implement hydraulic flow comparison
This model
10.9 GPM
Average
21.7 GPM
Low
5.3 GPM
High
43 GPM
Total hydraulic flow comparison
This model
10.9 GPM
Average
21.9 GPM
Low
4 GPM
High
60 GPM
Hydraulic pressure comparison
This model
1,900 psi
Average
2,726.4 psi
Low
435 psi
High
3,046 psi
Hydraulic fluid capacity comparison
This model
10 gal
Average
14.9 gal
Low
2.8 gal
High
43.7 gal
John Deere 5215 Extra Hydraulic Notes
Hydraulic flow note
With about 10.9 GPM implement flow, the John Deere 5215 sits in the compact / utility hydraulic range and is best suited to normal loader use, small hydraulic implements and general utility work.
Hydraulic pressure note
At 1,900 psi, the John Deere 5215’s hydraulic system pressure matters most for lift force, cylinder force and loader response.
Rear remotes / SCV note
Rear remotes / SCVs depend on the tractor’s hydraulic package and options.
For hydraulic implements, match the implement to the available hydraulic flow (10.9 GPM), not just the number of remotes.
Check the operator manual or hydraulic package because SCV count can change by year, market and trim package.
Hydraulic system type note
The John Deere 5215’s hydraulic system type is closed-center, which is built for higher-pressure hydraulic control than a basic open-center setup.
Hydraulic fluid capacity note
Hydraulic fluid capacity on the John Deere 5215 is 10 gal, but the correct oil type and fill/check procedure should still come from the official manual.
Official information note
Mistakes do happen. Hydraulic flow, pump flow, implement flow, pressure, rear remote / SCV setup and fluid capacity can change by year, market, transmission, pump option, loader package and hydraulic package. Please check the operator manual and official deere.com website for official information.
