The John Deere 310E coolant capacity is 24 gal (90.8 L). The listed coolant is John Deere Cool-Gard II, with 50/50 coolant and water mix guidance.
John Deere 310E Coolant Capacity Specs
| Coolant capacity | 24 gal (90.8 L) |
|---|---|
| Coolant type | John Deere Cool-Gard II |
| Antifreeze mix | 50/50 coolant and water mix |
| Engine horsepower | 76 hp |
| Engine displacement | 276 cu in (4.52 L) |
John Deere 310E Coolant Capacity Guide
Coolant capacity guide
Compared with a broad older small tractor guide, not the full tractor dataset.
John Deere 310E Coolant Service Notes
| Coolant capacity note | The useful service number here is 24 gal (90.8 L). Keep some extra coolant available because trapped air can lower the level after the first warm-up |
|---|---|
| Coolant service note | Use 24 gal (90.8 L) as the refill amount for the John Deere 310E, but do not mix coolant types blindly. The listed coolant detail is John Deere Cool-Gard II and 50/50 coolant and water mix |
| Coolant type note | The listed coolant type for the John Deere 310E is John Deere Cool-Gard II. Match the coolant chemistry before topping up or flushing the system |
| Antifreeze mix note | The listed antifreeze mix for the John Deere 310E is 50/50 coolant and water mix. Mix ratio affects freeze protection, boil protection and corrosion control |
| Refill check | When refilling the John Deere 310E, do not pour in 24 gal (90.8 L) and walk away. Fill slowly, run the engine, let it cool and recheck the level |
| Engine context | The John Deere 310E engine specs listed with this page are engine horsepower 76 hp and engine displacement 276 cu in (4.52 L). They help identify the machine, but they are not a substitute for the coolant capacity |
John Deere 310E Coolant Capacity FAQ
What is the John Deere 310E cooling system capacity?
A full coolant refill on the John Deere 310E is listed at 24 gal (90.8 L). Fill slowly and allow for a small top-up after the first heat cycle
What coolant is recommended for the John Deere 310E?
The John Deere 310E coolant listing shows John Deere Cool-Gard II. Use the operator manual and coolant label to confirm compatibility
How should coolant concentrate be mixed for the John Deere 310E?
The John Deere 310E uses 50/50 coolant and water mix where that mix is specified. Confirm the mix against your climate and manual
Can the John Deere 310E coolant level drop after refilling?
Check the John Deere 310E coolant level cold after service. Hot coolant is pressurized and dangerous, so let the system cool before opening the cap
Should I flush the John Deere 310E cooling system or just top it up?
If coolant condition is good, topping up may be enough. If it is old or contaminated, a full drain and refill is safer for the John Deere 310E
Mistakes do happen. Tractor coolant capacity and coolant type can change by year, market, engine, radiator setup and service procedure. Check the operator manual, service manual and official deere.com website before draining, flushing or refilling the cooling system.
