The John Deere 260 tractor hydraulic pump flow is 12.5 GPM, and hydraulic system pressure is 2,000 psi.
Hydraulic pump flow12.5 GPM
Implement flow7.5 GPM
Total hydraulic flow7.5 GPM
Hydraulic pressure2,000 psi
Hydraulic system typeopen-center
John Deere 260 Hydraulic Flow Details
Hydraulic pump flow
12.5 GPM
Implement hydraulic flow
7.5 GPM
Total hydraulic flow
7.5 GPM
Hydraulic system pressure
2,000 psi
Hydraulic system type
open-center
Hydraulic Flow Comparison Chart
Hydraulic pump flow comparison
This model
12.5 GPM
Average
17.3 GPM
Low
1.2 GPM
High
110 GPM
Implement hydraulic flow comparison
This model
7.5 GPM
Average
17.1 GPM
Low
1.2 GPM
High
110 GPM
Total hydraulic flow comparison
This model
7.5 GPM
Average
16.5 GPM
Low
1.2 GPM
High
70 GPM
Hydraulic pressure comparison
This model
2,000 psi
Average
2,330.1 psi
Low
435 psi
High
3,625 psi
John Deere 260 Extra Hydraulic Notes
Hydraulic flow note
The John Deere 260 should be matched to implements that fit its 7.5 GPM hydraulic-flow range.
Hydraulic pressure note
At 2,000 psi, the John Deere 260’s hydraulic system pressure matters most for lift force, cylinder force and loader response.
Rear remotes / SCV note
Rear remotes / SCVs depend on the tractor’s hydraulic package and options.
For hydraulic implements, match the implement to the available hydraulic flow (7.5 GPM), not just the number of remotes.
Check the operator manual or hydraulic package because SCV count can change by year, market and trim package.
Hydraulic system type note
The John Deere 260 uses a open-center hydraulic setup, so compatibility depends on both the attachment and valve configuration.
Official information note
Mistakes do happen. Hydraulic flow, pump flow, implement flow, pressure, rear remote / SCV setup and fluid capacity can change by year, market, transmission, pump option, loader package and hydraulic package. Please check the operator manual and official deere.com website for official information.
