The Bobcat S 175 H skid-steer battery size is Group 24, and it uses a 12-volt electrical system. Its 800 CCA rating is high for Bobcat skid-steers in this dataset.
ModelS 175 H
BrandBobcat
Voltage12 V
EquipmentSkid Steer
Voltage
12 V
Cold cranking
800 CCA
Battery size
Group 24
Battery location
See details below
How this battery compares
Compared with other Bobcat skid-steer battery ratings in this dataset.
Cold cranking amps800 CCA
High
LowAverageHigh
Low 190 CCAMedian 650 CCAHigh 1000 CCA
BA
Battery specification
Model-specific replacement data
System voltage
12 V
Battery group size
Group 24
Cold cranking amps
800 CCA
RP
Replacement battery
What to match when buying
The Bobcat S175 skid steer loader typically requires a Group 24 battery with at least 600 cold cranking amps (CCA) for optimal performance. You can find suitable options from various retailers, including Bobcat dealers and auto parts stores.
LC
Battery location
Where the battery is mounted
The battery on the Bobcat S175 skid-steer loader is typically located under the seat or in the rear compartment of the machine. For specific battery specifications and replacement details, it's best to consult the owner's manual or the Bobcat parts catalog.
ID
Model details
Equipment identity
Brand
Bobcat
Model
S 175 H
Equipment class
Skid-Steer Loader
HOW
How to replace the battery
Basic replacement procedure
Park on level ground, lower the lift arms/attachment, stop the engine, remove the key and isolate electrical power. Open the battery access, disconnect the negative cable first and then positive, remove the hold-down and lift out the battery. Clean the tray/terminals, install the replacement securely, connect positive first and negative last, then verify charging voltage and starting operation.
!
Bad battery symptoms
Signs the battery may be failing
Common signs are slow or no cranking, repeated clicking from the starter/solenoid, dim or flickering lights/display, electronics resetting during crank, needing frequent jump-starts, rapid self-discharge, corroded/swollen battery case, or resting voltage that quickly falls under load. Confirm cable condition and alternator output before condemning the battery.
?
What battery size fits the Bobcat S 175 H?
Quick answer
The official Bobcat S175 skid-steer loader battery group size is not explicitly listed on; however, the S175 uses a 12-volt battery system compatible with standard Group 24 or Group 27 deep-cycle batteries.
?
How many CCA does the Bobcat S 175 H need?
Quick answer
800 CCA. Best available fitment is based on closest same-brand/model-family match (S 175 ACS); an equal-or-higher CCA replacement is acceptable if the physical size and terminals match.
?
What voltage battery does the Bobcat S 175 H use?
Quick answer
The Bobcat S175 skid-steer loader uses a 12-volt battery. For replacement, it's important to check the specific model and year to ensure compatibility.
?
Where is the battery on the Bobcat S 175 H?
Quick answer
The battery on the Bobcat S175 skid-steer loader is typically located under the seat or in the rear compartment of the machine. For specific battery specifications and replacement details, it's best to consult the owner's manual or the Bobcat parts catalog.
?
What is the best replacement battery for the Bobcat S 175 H?
Quick answer
The Bobcat S175 skid steer loader typically requires a Group 24 battery with at least 600 cold cranking amps (CCA) for optimal performance. You can find suitable options from various retailers, including Bobcat dealers and auto parts stores.
Disclaimer: Battery specifications are for general reference and may vary by year, serial number or configuration. Always verify fitment and electrical requirements before purchase or installation. See the Bobcat website for manufacturer information.
