The Case 410 skid-steer battery size is Group 31, and it uses a 12-volt electrical system. Its 800 CCA rating is average for Case skid-steers in this dataset.
Model410
BrandCase
Voltage12 V
EquipmentSkid Steer
Voltage
12 V
Cold cranking
800 CCA
Battery size
Group 31
Battery location
See details below
How this battery compares
Compared with other Case skid-steer battery ratings in this dataset.
Cold cranking amps800 CCA
Average
LowAverageHigh
Low 185 CCAMedian 800 CCAHigh 1835 CCA
BA
Battery specification
Model-specific replacement data
System voltage
12 V
Battery group size
Group 31
Cold cranking amps
800 CCA
RP
Replacement battery
What to match when buying
Use a heavy-duty 12 V starting battery in BCI Group 31 with about 800 CCA (or higher), provided the case dimensions, hold-down and terminal orientation match. AGM is a good upgrade for vibration resistance; verify the machine serial number before purchase.
LC
Battery location
Where the battery is mounted
The battery on the Case 410 skid steer loader is typically located under the rear hood or behind a side panel for easy access. For replacement specs, consult the loader's manual or a parts supplier like NAPA for the correct battery type and year-specific details.
ID
Model details
Equipment identity
Brand
Case
Model
410
Equipment class
Skid-Steer Loader
HOW
How to replace the battery
Basic replacement procedure
Park on level ground, lower the lift arms/attachment, stop the engine, remove the key and isolate electrical power. Open the battery access, disconnect the negative cable first and then positive, remove the hold-down and lift out the battery. Clean the tray/terminals, install the replacement securely, connect positive first and negative last, then verify charging voltage and starting operation.
!
Bad battery symptoms
Signs the battery may be failing
Common symptoms of a bad battery in a Case 410 skid steer loader include failure to start, intermittent starting issues, and dashboard warning lights. For battery specifications and replacement details, refer to the Case parts manuals.
?
What battery size fits the Case 410?
Quick answer
Group 31. Best available fitment is based on closest same-brand/model-family match (430); confirm tray dimensions, terminal layout, and serial number before ordering.
?
How many CCA does the Case 410 need?
Quick answer
The recommended battery for the Case 410 Skid Steer Loader typically has a Cold Cranking Amps (CCA) rating of around 600 to 800 CCA. It's important to check the specific model requirements for the exact specifications.
?
What voltage battery does the Case 410 use?
Quick answer
?
Where is the battery on the Case 410?
Quick answer
The battery on the Case 410 skid steer loader is typically located under the rear hood or behind a side panel for easy access. For replacement specs, consult the loader's manual or a parts supplier like NAPA for the correct battery type and year-specific details.
?
What is the best replacement battery for the Case 410?
Quick answer
Use a heavy-duty 12 V starting battery in BCI Group 31 with about 800 CCA (or higher), provided the case dimensions, hold-down and terminal orientation match. AGM is a good upgrade for vibration resistance; verify the machine serial number before purchase.
Disclaimer: Battery specifications are for general reference and may vary by year, serial number or configuration. Always verify fitment and electrical requirements before purchase or installation. See the Case website for manufacturer information.
