The Case 410 S 3 skid-steer battery size is Group 31, and it uses a 12-volt electrical system. Its 800 CCA rating is average for Case skid-steers in this dataset.
Model410 S 3
BrandCase
Voltage12 V
EquipmentSkid Steer
Voltage
12 V
Cold cranking
800 CCA
Battery size
Group 31
Battery location
See details below
How this battery compares
Compared with other Case skid-steer battery ratings in this dataset.
Cold cranking amps800 CCA
Average
LowAverageHigh
Low 185 CCAMedian 800 CCAHigh 1835 CCA
BA
Battery specification
Model-specific replacement data
System voltage
12 V
Battery group size
Group 31
Cold cranking amps
800 CCA
RP
Replacement battery
What to match when buying
The best replacement battery for a Case 410 S 3 skid steer loader typically requires a battery that meets the specific voltage and size specifications outlined in the owner's manual. It's recommended to consult the manual or a dealer for the exact battery model compatible with your skid steer.
LC
Battery location
Where the battery is mounted
The battery on the Case 410 Series III Skid Steer Loader is typically located under the seat or in the rear compartment of the machine. For specific battery specifications and replacement details, refer to the owner's manual or manufacturer's guidelines.
ID
Model details
Equipment identity
Brand
Case
Model
410 S 3
Equipment class
Skid-Steer Loader
HOW
How to replace the battery
Basic replacement procedure
Park on level ground, lower the lift arms/attachment, stop the engine, remove the key and isolate electrical power. Open the battery access, disconnect the negative cable first and then positive, remove the hold-down and lift out the battery. Clean the tray/terminals, install the replacement securely, connect positive first and negative last, then verify charging voltage and starting operation.
!
Bad battery symptoms
Signs the battery may be failing
Common symptoms of a bad battery in a Case 410 S 3 skid steer loader include failure to start, intermittent starting issues, and dashboard warning lights. For battery specifications and replacement details, refer to the Case parts manuals.
?
What battery size fits the Case 410 S 3?
Quick answer
The official battery group size for the Case 410 S 3 skid steer loader is Group 31. For replacement, it's important to check the specific battery specifications to ensure compatibility.
?
How many CCA does the Case 410 S 3 need?
Quick answer
800 CCA. Best available fitment is based on closest same-brand/model-family match (420 S 3); an equal-or-higher CCA replacement is acceptable if the physical size and terminals match.
?
What voltage battery does the Case 410 S 3 use?
Quick answer
The official battery voltage for the Case 410 S 3 skid steer loader is 12 volts. For replacement, it's important to check the specific model's manual for compatible battery specifications.
?
Where is the battery on the Case 410 S 3?
Quick answer
The battery on the Case 410 Series III Skid Steer Loader is typically located under the seat or in the rear compartment of the machine. For specific battery specifications and replacement details, refer to the owner's manual or manufacturer's guidelines.
?
What is the best replacement battery for the Case 410 S 3?
Quick answer
The best replacement battery for a Case 410 S 3 skid steer loader typically requires a battery that meets the specific voltage and size specifications outlined in the owner's manual. It's recommended to consult the manual or a dealer for the exact battery model compatible with your skid steer.
Disclaimer: Battery specifications are for general reference and may vary by year, serial number or configuration. Always verify fitment and electrical requirements before purchase or installation. See the Case website for manufacturer information.
