The Cub Cadet Recon 60 deck belt part number found is 754-04212. The deck belt size found is 85 in (2,159 mm) long by 0.5 in (13 mm) wide. The drive belt part number found is 754-04212.
Deck belt part #754-04212
Deck belt sizelength 85 in (2,159 mm) and width 0.5 in (13 mm)
Drive belt part #754-04212
Deck size54 in deck
Cub Cadet Recon 60 Belt Size and Part Numbers
Mower deck belt part number
754-04212
Mower deck belt length
85 in (2,159 mm)
Mower deck belt width
0.5 in (13 mm)
Drive belt part number
754-04212
Deck size
54 in deck
Belt Size Comparison Chart
Belt length comparison
This model
85 in
Average
75 in
Low
50 in
High
105 in
Belt width comparison
This model
0.5 in
Average
0.5 in
Low
0.38 in
High
0.75 in
Mower deck size comparison
This model
54 in
Average
48 in
Low
38 in
High
60 in
Cub Cadet Recon 60 Belt Notes
Mower deck belt note
The Cub Cadet Recon 60 deck belt listing shows part number 754-04212, length 85 in (2,159 mm) and width 0.5 in (13 mm). Use the listed value as a buying guide, not a blind substitute for the deck-specific parts diagram
Drive belt note
The Cub Cadet Recon 60 drive or transmission belt part number captured here is 754-04212. This is separate from the mower deck belt
Deck size note
The captured mower deck size for the Cub Cadet Recon 60 is 54 in deck. Deck size matters because the same model family can use different belts with different decks
Fitment note
Belts are cheap until you buy the wrong one twice. On the Cub Cadet Recon 60, confirm deck size, belt route and OEM part number before ordering
Cub Cadet Recon 60 Belt Size FAQ
Is a close belt length good enough for the Cub Cadet Recon 60 deck?
The deck belt length found is 85 in (2,159 mm). Close is not the same as correct. A belt that is slightly short can overload bearings, while one slightly long can slip or fail to engage the blades cleanly
Can you replace the Cub Cadet Recon 60 belt with the same length but different width?
The deck belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right
What is the fastest way to confirm the Cub Cadet Recon 60 deck belt?
Start with the captured 54 in deck deck and the deck belt value 85 in (2,159 mm). Then check the belt routing decal or parts diagram so you do not order a belt for the wrong deck
Official information note
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official cubcadet.com before ordering a replacement belt.
