The John Deere D130 coolant capacity is 12 gal (45.4 L). Use this as the cooling-system refill amount and recheck the level after the engine cools.
John Deere D130 Coolant Capacity Specs
| Coolant capacity | 12 gal (45.4 L) |
|---|---|
| Engine horsepower | 22 hp |
John Deere D130 Coolant Capacity Guide
Coolant capacity guide
Compared with a broad ztrak / mower guide, not the full tractor dataset.
John Deere D130 Coolant Service Notes
| Coolant capacity note | The John Deere D130 cooling system is listed at 12 gal (45.4 L). Final level can settle after the first heat cycle, so recheck the level after service |
|---|---|
| Coolant service note | The John Deere D130 should be filled by capacity first, then verified by the actual level marks after the engine cools |
| Refill check | After a drain and refill on the John Deere D130, the cooling system can burp air. Recheck the level after the first warm-up and cool-down cycle |
| Engine context | For comparison, the John Deere D130 engine details listed here are engine horsepower 22 hp. The coolant capacity remains the service number to use for refilling |
John Deere D130 Coolant Capacity FAQ
How much coolant does the John Deere D130 take?
The cooling system capacity for the John Deere D130 is 12 gal (45.4 L). This is the main refill figure for a drain, flush or coolant change
Do I need to recheck coolant level after servicing the John Deere D130?
Fill the John Deere D130 slowly, run it with the heater/thermostat cycle where applicable, let it cool and check the level again. That helps catch trapped air
When should contaminated coolant be replaced in the John Deere D130?
Flush the John Deere D130 cooling system if the coolant is dirty, contaminated, badly diluted or overdue for service. A simple top-up does not fix old coolant chemistry
Mistakes do happen. Tractor coolant capacity and coolant type can change by year, market, engine, radiator setup and service procedure. Check the operator manual, service manual and official deere.com website before draining, flushing or refilling the cooling system.







