Antifreeze mix40/60 coolant and water mixFreeze/boil protection
John Deere 4044M Coolant Capacity Specs
Coolant capacity
13 gal (49.2 L)
Coolant type
John Deere Cool-Gard II
Antifreeze mix
40/60 coolant and water mix
Engine model
Yanmar 4TNV
Engine horsepower
42.5 hp
Engine displacement
134.3 cu in (2.2 L)
John Deere 4044M Coolant Capacity Guide
Coolant capacity guide
This model
13 gal
Class low
1.5 gal
Class typical
3.5 gal
Class high
6 gal
Compared with a broad compact tractor guide, not the full tractor dataset.
John Deere 4044M Coolant Service Notes
Coolant capacity note
The John Deere 4044M cooling system is listed at 13 gal (49.2 L). Final level can settle after the first heat cycle, so recheck the level after service
Coolant service note
Use 13 gal (49.2 L) as the refill amount for the John Deere 4044M, but do not mix coolant types blindly. The listed coolant detail is John Deere Cool-Gard II and 40/60 coolant and water mix
Coolant type note
The listed coolant type for the John Deere 4044M is John Deere Cool-Gard II. Match the coolant chemistry before topping up or flushing the system
Antifreeze mix note
The listed antifreeze mix for the John Deere 4044M is 40/60 coolant and water mix. Mix ratio affects freeze protection, boil protection and corrosion control
Refill check
When refilling the John Deere 4044M, do not pour in 13 gal (49.2 L) and walk away. Fill slowly, run the engine, let it cool and recheck the level
Engine context
The engine context for the John Deere 4044M is engine model Yanmar 4TNV, engine horsepower 42.5 hp, and engine displacement 134.3 cu in (2.2 L). Use this for comparison only; the refill amount is the coolant capacity above
John Deere 4044M Coolant Capacity FAQ
What is the refill amount for the John Deere 4044M cooling system?
A full coolant refill on the John Deere 4044M is listed at 13 gal (49.2 L). Fill slowly and allow for a small top-up after the first heat cycle
What should I match when topping up coolant in the John Deere 4044M?
The John Deere 4044M coolant listing shows John Deere Cool-Gard II. Use the operator manual and coolant label to confirm compatibility
How should coolant concentrate be mixed for the John Deere 4044M?
Use the listed 40/60 coolant and water mix mix when refilling the John Deere 4044M. Too much water weakens protection; too much concentrate can also reduce cooling performance
Should I run the John Deere 4044M after adding coolant?
Check the John Deere 4044M coolant level cold after service. Hot coolant is pressurized and dangerous, so let the system cool before opening the cap
When is a full coolant flush better than a top-up on the John Deere 4044M?
If coolant condition is good, topping up may be enough. If it is old or contaminated, a full drain and refill is safer for the John Deere 4044M
Official information note
Mistakes do happen. Tractor coolant capacity and coolant type can change by year, market, engine, radiator setup and service procedure. Check the operator manual, service manual and official deere.com website before draining, flushing or refilling the cooling system.
