For the John Deere 2950, coolant capacity is 9.5 gal (36 L). Coolant choice is listed as John Deere Cool-Gard II, with 60/40 coolant and water mix guidance.
John Deere 2950 Coolant Capacity Specs
| Coolant capacity | 9.5 gal (36 L) |
|---|---|
| Coolant type | John Deere Cool-Gard II |
| Antifreeze mix | 60/40 coolant and water mix |
| Engine displacement | 5.9 L (360 cu in) |
John Deere 2950 Coolant Capacity Guide
Coolant capacity guide
Compared with a broad compact tractor guide, not the full tractor dataset.
John Deere 2950 Coolant Service Notes
| Coolant capacity note | The John Deere 2950 coolant capacity is 9.5 gal (36 L). Treat it as a cooling-system amount, not a radiator-only top-up amount |
|---|---|
| Coolant service note | For a full coolant service on the John Deere 2950, plan around 9.5 gal (36 L) and match the listed coolant guidance: John Deere Cool-Gard II and 60/40 coolant and water mix |
| Coolant type note | The John Deere 2950 coolant type is John Deere Cool-Gard II. Wrong coolant chemistry can reduce corrosion, freeze and boil protection |
| Antifreeze mix note | The listed mix for the John Deere 2950 is 60/40 coolant and water mix. Keep the coolant strength in range after a drain, flush or top-up |
| Refill check | After a drain and refill on the John Deere 2950, the cooling system can burp air. Recheck the level after the first warm-up and cool-down cycle |
| Engine context | The John Deere 2950 engine specs listed with this page are engine displacement 5.9 L (360 cu in). They help identify the machine, but they are not a substitute for the coolant capacity |
John Deere 2950 Coolant Capacity FAQ
How much coolant is needed for a John Deere 2950 coolant change?
The cooling system capacity for the John Deere 2950 is 9.5 gal (36 L). This is the main refill figure for a drain, flush or coolant change
Can I use John Deere Cool-Gard in the John Deere 2950?
For the John Deere 2950, the coolant type is listed as John Deere Cool-Gard II. Avoid mixing incompatible coolant products
What mix ratio should I use when refilling the John Deere 2950?
For the John Deere 2950, the coolant mix is listed as 60/40 coolant and water mix. Do not dilute the system with too much plain water
Should I bleed air after changing coolant in the John Deere 2950?
Fill the John Deere 2950 slowly, run it with the heater/thermostat cycle where applicable, let it cool and check the level again. That helps catch trapped air
When should I flush the John Deere 2950 cooling system?
Flush the John Deere 2950 cooling system if the coolant is dirty, contaminated, badly diluted or overdue for service. A simple top-up does not fix old coolant chemistry
Mistakes do happen. Tractor coolant capacity and coolant type can change by year, market, engine, radiator setup and service procedure. Check the operator manual, service manual and official deere.com website before draining, flushing or refilling the cooling system.
