For the John Deere 70A, coolant capacity is 8.5 gal (32.2 L). Coolant choice is listed as John Deere Cool-Gard II, with The recommended coolant for the John Deere 25C tractor is John Deere Cool-Gard II, which guidance.
Coolant capacity8.5 gal (32.2 L)Cooling system refill amount
Antifreeze mixThe recommended coolant for the John Deere 25C tractor is John Deere Cool-Gard II, whichFreeze/boil protection
John Deere 70A Coolant Capacity Specs
Coolant capacity
8.5 gal (32.2 L)
Coolant type
John Deere Cool-Gard II
Antifreeze mix
The recommended coolant for the John Deere 25C tractor is John Deere Cool-Gard II, which
Engine horsepower
68 hp
Engine displacement
127.1 cu in (2.08 L)
John Deere 70A Coolant Capacity Guide
Coolant capacity guide
This model
8.5 gal
Class low
0.8 gal
Class typical
2.5 gal
Class high
5 gal
Compared with a broad older small tractor guide, not the full tractor dataset.
John Deere 70A Coolant Service Notes
Coolant capacity note
The John Deere 70A coolant capacity is 8.5 gal (32.2 L). Treat it as a cooling-system amount, not a radiator-only top-up amount
Coolant service note
For a full coolant service on the John Deere 70A, plan around 8.5 gal (32.2 L) and match the listed coolant guidance: John Deere Cool-Gard II and The recommended coolant for the John Deere 25C tractor is John Deere Cool-Gard II, which
Coolant type note
The John Deere 70A coolant type is John Deere Cool-Gard II. Wrong coolant chemistry can reduce corrosion, freeze and boil protection
Antifreeze mix note
The listed mix for the John Deere 70A is The recommended coolant for the John Deere 25C tractor is John Deere Cool-Gard II, which. Keep the coolant strength in range after a drain, flush or top-up
Refill check
After a drain and refill on the John Deere 70A, the cooling system can burp air. Recheck the level after the first warm-up and cool-down cycle
Engine context
For comparison, the John Deere 70A engine details listed here are engine horsepower 68 hp and engine displacement 127.1 cu in (2.08 L). The coolant capacity remains the service number to use for refilling
John Deere 70A Coolant Capacity FAQ
How much coolant is needed for a John Deere 70A coolant change?
The cooling system capacity for the John Deere 70A is 8.5 gal (32.2 L). This is the main refill figure for a drain, flush or coolant change
Can I use John Deere Cool-Gard in the John Deere 70A?
For the John Deere 70A, the coolant type is listed as John Deere Cool-Gard II. Avoid mixing incompatible coolant products
What mix ratio should I use when refilling the John Deere 70A?
The John Deere 70A uses The recommended coolant for the John Deere 25C tractor is John Deere Cool-Gard II, which where that mix is specified. Confirm the mix against your climate and manual
Should I bleed air after changing coolant in the John Deere 70A?
Fill the John Deere 70A slowly, run it with the heater/thermostat cycle where applicable, let it cool and check the level again. That helps catch trapped air
When should I flush the John Deere 70A cooling system?
Flush the John Deere 70A cooling system if the coolant is dirty, contaminated, badly diluted or overdue for service. A simple top-up does not fix old coolant chemistry
Official information note
Mistakes do happen. Tractor coolant capacity and coolant type can change by year, market, engine, radiator setup and service procedure. Check the operator manual, service manual and official deere.com website before draining, flushing or refilling the cooling system.
