The John Deere 2446F belongs in the tractor bracket by physical dimensions. It is worth checking the listed measurements against your shed, gate, trailer and storage space.
Storage fit note
For the John Deere 2446F, storage fit is only clear after checking the actual opening. With the listed size figures are the main storage check, allow margin for attachments.
Wheelbase note
The John Deere 2446F lists a 68.5 in (5 ft 8.5 in) / 1,739.9 mm wheelbase. It is a good size-comparison spec for buyers.
Ground clearance note
The John Deere 2446F’s ground clearance is 12.5 in (1 ft 0.5 in) / 317.5 mm. This is a practical fitment number, not just a spec-sheet extra.
Tread width note
Rear tread for the John Deere 2446F is listed as 15.3 in (1 ft 3.3 in) / 388.6 mm. The front figure was not captured clearly.
Storage Tips
The safe storage check is simple: compare the tractor against the actual opening, not a rough shed size.
Recommended storage clearance: measure door height, door width, bay depth and attachment clearance.
The safest storage check is always the real machine against the real opening.
A 68.5 in wheelbase means the approach into the storage bay matters, not just the doorway width.
Storage FAQ
Will it fit in a garage?
If your garage door is close to height not captured tall or width not captured wide, count it as too tight. The safer check for the John Deere 2446F is around a measured opening with spare clearance on every side.
What size door should I check?
The clean check is the tractor height plus clearance high, the tractor width plus side clearance wide and the tractor length plus attachment room deep. That gives margin over the listed height not captured height, width not captured width and length not captured length.
Do attachments change the storage size?
Yes. The published length not captured length is useful for the bare tractor, but the real storage number is the longest point from front attachment to rear attachment.
How much maneuvering room should I allow?
Use the 68.5 in wheelbase as the handling clue. If the approach is angled, a the tractor width plus side clearance door may still feel tight, so leave about 13 ft to straighten up.
Official information note
Mistakes do happen. Tractor dimensions can change by year, tire setup, cab/ROPS setup, attachments and market. Please check the operator manual, build sheet and official deere.com website for official information.
