The John Deere 8010 tractor hydraulic pump flow is 35 GPM, and hydraulic system pressure is 2,900 psi.
Hydraulic pump flow35 GPM
Implement flow60 GPM
Total hydraulic flow30 GPM
Hydraulic pressure2,900 psi
Hydraulic system typeopen-center
Hydraulic fluid capacity25 gal
John Deere 8010 Hydraulic Flow Details
Hydraulic pump flow
35 GPM
Implement hydraulic flow
60 GPM
Total hydraulic flow
30 GPM
Hydraulic system pressure
2,900 psi
Hydraulic system type
open-center
Hydraulic fluid capacity
25 gal
Hydraulic Flow Comparison Chart
Hydraulic pump flow comparison
This model
35 GPM
Average
33.4 GPM
Low
2.5 GPM
High
78 GPM
Implement hydraulic flow comparison
This model
60 GPM
Average
32.8 GPM
Low
2.4 GPM
High
115 GPM
Total hydraulic flow comparison
This model
30 GPM
Average
33.6 GPM
Low
2.4 GPM
High
85 GPM
Hydraulic pressure comparison
This model
2,900 psi
Average
2,569.3 psi
Low
300 psi
High
3,046 psi
Hydraulic fluid capacity comparison
This model
25 gal
Average
26.1 gal
Low
0.6 gal
High
79.3 gal
John Deere 8010 Extra Hydraulic Notes
Hydraulic flow note
For hydraulic work, the key number on the John Deere 8010 is 60 GPM implement flow; that points toward large hydraulic implements and high-demand farm equipment where SCV flow matters.
Hydraulic pressure note
The John Deere 8010’s hydraulic pressure is listed at 2,900 psi, which is strong tractor hydraulic pressure; flow still decides attachment speed while pressure affects force.
Rear remotes / SCV note
Rear remotes / SCVs are mentioned, but the exact count is not clearly confirmed in the scraped data.
For hydraulic implements, match the implement to the available hydraulic flow (60 GPM), not just the number of remotes.
Check the operator manual or hydraulic package because SCV count can change by year, market and trim package.
Hydraulic system type note
The John Deere 8010 uses a open-center hydraulic setup, so compatibility depends on both the attachment and valve configuration.
Hydraulic fluid capacity note
Hydraulic fluid capacity on the John Deere 8010 is 25 gal, but the correct oil type and fill/check procedure should still come from the official manual.
Official information note
Mistakes do happen. Hydraulic flow, pump flow, implement flow, pressure, rear remote / SCV setup and fluid capacity can change by year, market, transmission, pump option, loader package and hydraulic package. Please check the operator manual and official deere.com website for official information.
