The John Deere 130 tractor hydraulic pump flow is 30 GPM, and hydraulic system pressure is 1,500 psi.
Hydraulic pump flow30 GPM
Implement flow21.4 GPM
Total hydraulic flow30 GPM
Hydraulic pressure1,500 psi
Hydraulic system typeopen-center
John Deere 130 Hydraulic Flow Details
Hydraulic pump flow
30 GPM
Implement hydraulic flow
21.4 GPM
Total hydraulic flow
30 GPM
Hydraulic system pressure
1,500 psi
Hydraulic system type
open-center
Hydraulic Flow Comparison Chart
Hydraulic pump flow comparison
This model
30 GPM
Average
20.7 GPM
Low
3.7 GPM
High
110 GPM
Implement hydraulic flow comparison
This model
21.4 GPM
Average
21.2 GPM
Low
3.7 GPM
High
110 GPM
Total hydraulic flow comparison
This model
30 GPM
Average
19.9 GPM
Low
3.7 GPM
High
55 GPM
Hydraulic pressure comparison
This model
1,500 psi
Average
2,198.4 psi
Low
700 psi
High
4,200 psi
John Deere 130 Extra Hydraulic Notes
Hydraulic flow note
The John Deere 130’s total flow is higher than implement flow, so use the implement-flow number when matching hydraulic tools and SCV-driven equipment.
Hydraulic pressure note
The John Deere 130’s hydraulic pressure is listed at 1,500 psi, which is lower-pressure; flow still decides attachment speed while pressure affects force.
Rear remotes / SCV note
Rear remotes / SCVs depend on the tractor’s hydraulic package and options.
For hydraulic implements, match the implement to the available hydraulic flow (21.4 GPM), not just the number of remotes.
Check the operator manual or hydraulic package because SCV count can change by year, market and trim package.
Hydraulic system type note
The John Deere 130 uses a open-center hydraulic setup, so compatibility depends on both the attachment and valve configuration.
Official information note
Mistakes do happen. Hydraulic flow, pump flow, implement flow, pressure, rear remote / SCV setup and fluid capacity can change by year, market, transmission, pump option, loader package and hydraulic package. Please check the operator manual and official deere.com website for official information.
