New Holland TM165 Coolant Capacity (6.9 gal)

Quick answer:

The New Holland TM165 tractor cooling system capacity is 6.9 gal | 26 L, coolant type is extended-life OAT coolant meeting MAT 3724, and coolant change interval is every 1,500 hours or 3 years.

New Holland TM165 Coolant Capacity Details

Cooling system capacity 6.9 gal | 26 L
Coolant type Extended-life OAT coolant meeting MAT 3724
Coolant change interval Every 1,500 hours or 3 years
Coolant mixture ratio The recommended coolant mixture ratio for a New Holland TM165 tractor is typically 50% antifreeze and 50% water
Radiator cap pressure 10 psi | 70 kPa

Coolant Capacity Comparison Chart

Coolant Capacity Comparison

This model

6.9 gal

Average

5.5 gal

Low

3 gal

High

9 gal

Benchmarks use practical low, average and high coolant-capacity ranges for the utility tractor category. Use the exact tractor manual before buying coolant.

New Holland TM165 Extra Coolant Notes

Engine horsepower 165 hp | 123 kW
Engine displacement 7.5 L | 457 cu in
Capacity note For the New Holland TM165, the listed cooling system capacity is 6.9 gal | 26 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note The recommended coolant mixture ratio for a New Holland TM165 tractor is typically 50% antifreeze and 50% water.
Radiator cap note The radiator cap pressure listed for the New Holland TM165 is 10 psi | 70 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.

New Holland TM165 Coolant FAQs

How much coolant does a New Holland TM165 take?

The New Holland TM165 takes 6.9 gal | 26 L of coolant. That is about normal for the utility tractor benchmark shown here, so plan it like a standard drain-and-refill rather than a tiny top-up.

Is the New Holland TM165 coolant capacity normal?

Yes, 6.9 gal | 26 L lands about where you would expect for this tractor category. The main thing is buying enough for a complete refill plus a small top-off amount.

How many coolant jugs do I need for a New Holland TM165?

This is more than a small top-off job. A 6.9 gal | 26 L system needs about 7 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 3.4 gal of concentrate and 3.4 gal of distilled water. In metric terms, that is roughly 6 x 5 L containers for a full premix refill.

Can I mix coolant types in a New Holland TM165?

Because the listed coolant is extended-life OAT coolant meeting MAT 3724, the clean move is to stay with the same approved chemistry. Do not casually mix it with old green conventional coolant; if the old coolant type is unknown, flush first or confirm what is already in the system. The listed mix is the recommended coolant mixture ratio for a New Holland TM165 tractor is typically 50% antifreeze and 50% water, so do not run straight water except as a short emergency move.

How much concentrate and water does a New Holland TM165 need?

With the listed the recommended coolant mixture ratio for a New Holland TM165 tractor is typically 50% antifreeze and 50% water mix, a full 6.9 gal | 26 L refill works out to about 3.4 gal of antifreeze concentrate and 3.4 gal of distilled water. If using premix, do not add extra water unless the product label says to.

Can I use a different radiator cap on a New Holland TM165?

The listed cap pressure is 10 psi | 70 kPa. Use the same pressure rating when replacing it. The cap is part of the cooling system, not just a lid, and the wrong rating can cause boil-over, leaks or pressure problems.

Official information note

Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official newholland.com website before draining, flushing or refilling the cooling system.