The deck belt size found is 108 in (2,743 mm) long by 0.5 in (13 mm) wide. The drive belt part number found is MIA10045. The drive belt size found is 95 in (2,413 mm) long by 0.5 in (13 mm) wide.
John Deere Z955R Belt Size and Part Numbers
| Mower deck belt length | 108 in (2,743 mm) |
|---|---|
| Mower deck belt width | 0.5 in (13 mm) |
| Drive belt part number | MIA10045 |
| Drive belt length | 95 in (2,413 mm) |
| Drive belt width | 0.5 in (13 mm) |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
John Deere Z955R Belt Notes
| Mower deck belt note | The John Deere Z955R deck belt measurement captured here is length 108 in (2,743 mm) and width 0.5 in (13 mm). Confirm the belt against the deck tag, belt decal or parts diagram before ordering |
|---|---|
| Drive belt note | The John Deere Z955R drive or transmission belt listing shows part number MIA10045, length 95 in (2,413 mm) and width 0.5 in (13 mm). Treat it as partial drive-belt data if no matching width or OEM part number is shown |
| Fitment note | For the John Deere Z955R, use the listed specs as a buying guide, but confirm against the operator manual, parts diagram or belt label before spending money |
John Deere Z955R Belt Size FAQ
What should you watch when fitting a 108 in (2,743 mm) deck belt on the John Deere Z955R?
A 108 in (2,743 mm) deck belt leaves little room for sloppy routing. This is a longer mower belt run, so twist, idler alignment and the belt keeper positions matter. A belt can be the right length and still fail if it is routed wrong. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each.
Should you buy the John Deere Z955R belt by length only?
No. The deck belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. Use length, width and OEM part number together where possible
Which John Deere Z955R belt needs more careful length matching?
The deck belt is longer here: deck 108 in (2,743 mm) versus drive 95 in (2,413 mm), about 13 in (330 mm) different. Do not cross-match them just because both are mower belts
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official John Deere parts catalog before ordering a replacement belt.
