The John Deere X724 deck belt part number found is M144202. The deck belt size found is 108 in (2,743 mm) long by 0.5 in (13 mm) wide. The drive belt part number found is M144202.
John Deere X724 Belt Size and Part Numbers
| Mower deck belt part number | M144202 |
|---|---|
| Mower deck belt length | 108 in (2,743 mm) |
| Mower deck belt width | 0.5 in (13 mm) |
| Drive belt part number | M144202 |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
John Deere X724 Belt Notes
| Mower deck belt note | The John Deere X724 deck belt listing shows part number M144202, length 108 in (2,743 mm) and width 0.5 in (13 mm). Confirm the belt against the deck tag, belt decal or parts diagram before ordering |
|---|---|
| Drive belt note | The John Deere X724 drive or transmission belt part number captured here is M144202. Treat it as partial drive-belt data if no matching width or OEM part number is shown |
| Fitment note | The blunt rule with the John Deere X724: part number beats guesswork. If the belt is off by even a small amount, it can slip, squeal, jump pulleys or wear fast |
John Deere X724 Belt Size FAQ
What should you watch when fitting a 108 in (2,743 mm) deck belt on the John Deere X724?
A 108 in (2,743 mm) deck belt leaves little room for sloppy routing. This is a longer mower belt run, so twist, idler alignment and the belt keeper positions matter. A belt can be the right length and still fail if it is routed wrong. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each.
Should you buy the John Deere X724 belt by length only?
No. The deck belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. Use length, width and OEM part number together where possible
What is the risk with the John Deere X724 drive belt part number?
The captured drive belt number is M144202. If the length and width are missing, a cheap cross-reference can still be wrong even when it claims to replace the OEM belt
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official John Deere parts catalog before ordering a replacement belt.
