The drive belt part number found is MIA10045. The drive belt size found is 95.5 in (2,426 mm) long by 0.5 in (13 mm) wide.
John Deere X110 Belt Size and Part Numbers
| Drive belt part number | MIA10045 |
|---|---|
| Drive belt length | 95.5 in (2,426 mm) |
| Drive belt width | 0.5 in (13 mm) |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
John Deere X110 Belt Notes
| Drive belt note | The John Deere X110 drive or transmission belt listing shows part number MIA10045, length 95.5 in (2,426 mm) and width 0.5 in (13 mm). This is separate from the mower deck belt |
|---|---|
| Fitment note | Before ordering a John Deere X110 belt, compare the old belt routing, pulley layout and deck size if available. A close-looking belt can still be wrong |
John Deere X110 Belt Size FAQ
Why can the correct John Deere X110 drive belt still not pull properly?
The drive belt length found is 95.5 in (2,426 mm). If the tractor still slips, the belt may be routed wrong, the idler may be weak, or the pulley faces may be polished. Length alone does not fix a worn drive system
Can you replace the John Deere X110 belt with the same length but different width?
The drive belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official John Deere parts catalog before ordering a replacement belt.
