The deck belt size found is 95 in (2,413 mm) long by 0.5 in (13 mm) wide. The drive belt part number found is M144202.
John Deere LR175 Belt Size and Part Numbers
| Mower deck belt length | 95 in (2,413 mm) |
|---|---|
| Mower deck belt width | 0.5 in (13 mm) |
| Drive belt part number | M144202 |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
John Deere LR175 Belt Notes
| Mower deck belt note | The John Deere LR175 deck belt measurement captured here is length 95 in (2,413 mm) and width 0.5 in (13 mm). Use the listed value as a buying guide, not a blind substitute for the deck-specific parts diagram |
|---|---|
| Drive belt note | The John Deere LR175 drive or transmission belt part number captured here is M144202. This is separate from the mower deck belt |
| Fitment note | For the John Deere LR175, use the listed specs as a buying guide, but confirm against the operator manual, parts diagram or belt label before spending money |
John Deere LR175 Belt Size FAQ
What should you watch when fitting a 95 in (2,413 mm) deck belt on the John Deere LR175?
A 95 in (2,413 mm) deck belt leaves little room for sloppy routing. This is a longer mower belt run, so twist, idler alignment and the belt keeper positions matter. A belt can be the right length and still fail if it is routed wrong. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each.
Can you replace the John Deere LR175 belt with the same length but different width?
The deck belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right
What is the risk with the John Deere LR175 drive belt part number?
The captured drive belt number is M144202. If the length and width are missing, a cheap cross-reference can still be wrong even when it claims to replace the OEM belt
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official John Deere parts catalog before ordering a replacement belt.
