The John Deere E140 deck belt part number found is GX21833. The deck belt length found is 48 in (1,219 mm). The drive belt part number found is GX21833. The drive belt size found is 95.5 in (2,426 mm) long by 0.5 in (13 mm) wide.
John Deere E140 Belt Size and Part Numbers
| Mower deck belt part number | GX21833 |
|---|---|
| Mower deck belt length | 48 in (1,219 mm) |
| Drive belt part number | GX21833 |
| Drive belt length | 95.5 in (2,426 mm) |
| Drive belt width | 0.5 in (13 mm) |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
John Deere E140 Belt Notes
| Mower deck belt note | The John Deere E140 deck belt listing shows part number GX21833 with length 48 in (1,219 mm). Confirm the belt against the deck tag, belt decal or parts diagram before ordering |
|---|---|
| Drive belt note | The John Deere E140 drive or transmission belt listing shows part number GX21833, length 95.5 in (2,426 mm) and width 0.5 in (13 mm). Treat it as partial drive-belt data if no matching width or OEM part number is shown |
| Fitment note | Before ordering a John Deere E140 belt, compare the old belt routing, pulley layout and deck size if available. A close-looking belt can still be wrong |
John Deere E140 Belt Size FAQ
What should you watch when fitting a 48 in (1,219 mm) deck belt on the John Deere E140?
A 48 in (1,219 mm) deck belt leaves little room for sloppy routing. This is a short belt run, so a small routing mistake or wrong pulley side can show up quickly as slipping, rubbing or poor engagement. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each keeper
Should you buy the John Deere E140 belt by length only?
No. The drive belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. Use length, width and OEM part number together where possible
Are the John Deere E140 deck and drive belt lengths close?
The deck belt is 48 in (1,219 mm) and the drive belt is 95.5 in (2,426 mm), about 47.5 in (1,206 mm) different. That is enough to treat them as separate belts when ordering
Is the captured John Deere E140 deck belt part number enough to buy from?
The captured deck belt number is GX21833. This number helps with OEM lookup, but the deck belt width was not fully captured here. Before buying aftermarket, confirm the exact deck or serial range
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official John Deere parts catalog before ordering a replacement belt.
