The John Deere 855 takes 4.1 quarts / 3.9 litres of engine oil with filter.
John Deere 855 Oil Capacity and Type
| Engine Oil Capacity | 4.1 qt / 3.9 L with filter |
| Recommended Oil Name | John Deere Plus-50 II or John Deere Torq-Gard |
| Recommended Oil Type | Diesel-rated SAE 10W-30 or 15W-40 engine oil |
| Engine | Yanmar 3TN75RJ diesel engine |
| Engine Power | 24 HP gross |
| PTO Power | 19 HP |
| Cylinders | 3-cylinder diesel |
| Displacement | 60.7 cu in / 1.0 L |
| Cooling System | Liquid-cooled |
| Oil Filter | John Deere M801002 |
| Oil Change Interval | Every 200 hours or annually |
How Much Oil Does a John Deere 855 Take?
The John Deere 855 takes 4.1 quarts / 3.9 litres of engine oil when changing the engine oil and filter.
Use a quality diesel-rated SAE 10W-30 or 15W-40 engine oil. John Deere Plus-50 II and John Deere Torq-Gard are both suitable choices, depending on temperature, availability, and the oil rating.
Fill close to 3.9 litres, run the engine briefly, shut it off, wait a few minutes, then check the dipstick. Top up slowly if needed. Do not overfill it.
Quick Specs Overview
4.1 qtEngine Oil
10W-30 / 15W-40Oil Type
200 hrsOil Interval
24 HPEngine Power
Best Oil to Use
- John Deere Plus-50 II diesel engine oil
- John Deere Torq-Gard diesel engine oil
- SAE 10W-30 for cooler operating conditions
- SAE 15W-40 for warmer operating conditions
- Diesel-rated engine oil suitable for compact utility tractors
- Replace the engine oil filter at every engine oil change
Oil Capacity Comparison
Oil Change Intervals
| Engine Oil | Every 200 hours or annually |
| Engine Oil Filter | Replace every oil change |
| Air Filter | Check regularly; replace as needed |
| Fuel Filter | Replace as part of regular diesel service |
| Transmission / Hydraulic Oil | Service according to operator manual schedule |
| Front Axle Oil | Check regularly on MFWD models |
Other John Deere 855 Fluid Capacities
| Engine Oil | 4.1 qt / 3.9 L with filter |
| Fuel Tank | 6.6 gal / 25.0 L |
| Cooling System | 4.8 qt / 4.5 L |
| Transmission / Hydraulic System | 4.5 gal / 17.0 L |
| Front Axle Gearcase | 2.25 qt / 2.1 L |
| Transmission Type | Sundstrand Series 17 hydrostatic |
| Recommended Hydraulic Oil | John Deere Hy-Gard or Low-Viscosity Hy-Gard |
John Deere 855 Engine Specs
| Engine | Yanmar 3TN75RJ diesel |
| Displacement | 60.7 cu in / 1.0 L |
| Cylinders | 3-cylinder |
| Fuel Type | Diesel |
| Aspiration | Naturally aspirated |
| Cooling System | Liquid-cooled |
| Rated RPM | 3200 rpm |
| Gross Engine Power | 24 HP |
| PTO Power | 19 HP |
| Starter | Electric, 12 volt |
| Lubrication | Pressurized lubrication with replaceable oil filter |
Common Mistakes
- Using the common 3.8 quart figure instead of the operator manual figure of 4.1 quarts with filter
- Using gasoline-engine oil instead of diesel-rated engine oil
- Forgetting that the 4.1 quart capacity includes the oil filter
- Confusing engine oil with Hy-Gard transmission/hydraulic oil
- Skipping the oil filter when changing the oil
- Using the wrong oil filter instead of M801002 or a correct equivalent
- Ignoring the dipstick and relying only on the listed capacity
Summary
The John Deere 855 takes 4.1 quarts / 3.9 litres of engine oil with filter. The best oil choice is a diesel-rated SAE 10W-30 or 15W-40 engine oil, such as John Deere Plus-50 II or John Deere Torq-Gard. The 855 uses a Yanmar 3TN75RJ 3-cylinder liquid-cooled diesel engine with around 24 gross horsepower and 19 PTO horsepower. Change the engine oil and filter every 200 hours or annually, and always confirm the final oil level with the dipstick.







