The John Deere 260 deck belt part number found is M154202. The drive belt length found is 74 in (1,880 mm).
John Deere 260 Belt Size and Part Numbers
| Mower deck belt part number | M154202 |
|---|---|
| Drive belt length | 74 in (1,880 mm) |
Belt Size Comparison Chart
Belt length comparison
John Deere 260 Belt Notes
| Mower deck belt note | The John Deere 260 deck belt part number captured here is M154202. Confirm the belt against the deck tag, belt decal or parts diagram before ordering |
|---|---|
| Drive belt note | The John Deere 260 drive or transmission belt measurement captured here is length 74 in (1,880 mm). Treat it as partial drive-belt data if no matching width or OEM part number is shown |
| Fitment note | Belts are cheap until you buy the wrong one twice. On the John Deere 260, confirm belt route, old belt label and OEM part number before ordering |
John Deere 260 Belt Size FAQ
What should you check when fitting a 74 in (1,880 mm) drive belt on the John Deere 260?
The drive belt length found is 74 in (1,880 mm). This is a mid-length belt run, so routing and idler position still matter more than just matching a close-looking belt. Also check the idler spring and pulley grooves because drive belts can slip under load even when they look fine at idle
Is the captured John Deere 260 deck belt part number enough to buy from?
The captured deck belt number is M154202. This number helps with OEM lookup, but the deck belt length and width were not fully captured here. Before buying aftermarket, confirm the exact deck or serial range
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official John Deere parts catalog before ordering a replacement belt.
