The John Deere 216 deck belt part number found is M144202. The deck belt size found is 95 in (2,413 mm) long by 0.5 in (13 mm) wide. The drive belt part number found is M43820. The drive belt size found is 95 in (2,413 mm) long by 0.5 in (13 mm) wide.
John Deere 216 Belt Size and Part Numbers
| Mower deck belt part number | M144202 |
|---|---|
| Mower deck belt length | 95 in (2,413 mm) |
| Mower deck belt width | 0.5 in (13 mm) |
| Drive belt part number | M43820 |
| Drive belt length | 95 in (2,413 mm) |
| Drive belt width | 0.5 in (13 mm) |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
John Deere 216 Belt Notes
| Mower deck belt note | The John Deere 216 deck belt listing shows part number M144202, length 95 in (2,413 mm) and width 0.5 in (13 mm). Use the listed value as a buying guide, not a blind substitute for the deck-specific parts diagram |
|---|---|
| Drive belt note | The John Deere 216 drive or transmission belt listing shows part number M43820, length 95 in (2,413 mm) and width 0.5 in (13 mm). This is separate from the mower deck belt |
| Fitment note | The blunt rule with the John Deere 216: part number beats guesswork. If the belt is off by even a small amount, it can slip, squeal, jump pulleys or wear fast |
John Deere 216 Belt Size FAQ
What should you watch when fitting a 95 in (2,413 mm) deck belt on the John Deere 216?
A 95 in (2,413 mm) deck belt leaves little room for sloppy routing. This is a longer mower belt run, so twist, idler alignment and the belt keeper positions matter. A belt can be the right length and still fail if it is routed wrong. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each.
Can you replace the John Deere 216 belt with the same length but different width?
The deck belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right
Can you swap the John Deere 216 deck belt and drive belt if the measurements match?
Do not assume that. The captured sizes match at 95 in (2,413 mm) long by 0.5 in (13 mm) wide, but the part numbers differ: deck M144202 and drive M43820. Use the part number for the belt position, not just the tape-measure size
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official John Deere parts catalog before ordering a replacement belt.
