The Gehl RT185 skid-steer battery size is Group 31, and it uses a 12-volt electrical system. Its 720 CCA rating is average for Gehl skid-steers in this dataset.
ModelRT185
BrandGehl
Voltage12 V
EquipmentSkid Steer
Voltage
12 V
Cold cranking
720 CCA
Battery size
Group 31
Battery location
See details below
How this battery compares
Compared with other Gehl skid-steer battery ratings in this dataset.
Cold cranking amps720 CCA
Average
LowAverageHigh
Low 105 CCAMedian 800 CCAHigh 950 CCA
BA
Battery specification
Model-specific replacement data
System voltage
12 V
Battery group size
Group 31
Cold cranking amps
720 CCA
RP
Replacement battery
What to match when buying
Use a heavy-duty 12 V starting battery in BCI Group 31 with about 720 CCA (or higher), provided the case dimensions, hold-down and terminal orientation match. AGM is a good upgrade for vibration resistance; verify the machine serial number before purchase.
LC
Battery location
Where the battery is mounted
Family-match guidance: The battery on the Gehl RT175 skid steer loader is typically located under the operator's seat or behind an access panel on the rear of the machine. For replacement, use a battery with the same specifications as the original, commonly a 12-volt Group 24 or Group 27 deep-cycle battery. Verify the exact access panel/compartment for the machine serial number before service.
ID
Model details
Equipment identity
Brand
Gehl
Model
RT185
Equipment class
Skid-Steer Loader
HOW
How to replace the battery
Basic replacement procedure
Park on level ground, lower the lift arms/attachment, stop the engine, remove the key and isolate electrical power. Open the battery access, disconnect the negative cable first and then positive, remove the hold-down and lift out the battery. Clean the tray/terminals, install the replacement securely, connect positive first and negative last, then verify charging voltage and starting operation.
!
Bad battery symptoms
Signs the battery may be failing
Common symptoms of a bad battery in a Gehl RT185 skid steer loader include difficulty starting the engine, dim or flickering lights, and unresponsive controls. For battery specifications and replacement, refer to the manufacturer's guidelines on Gehl's official website.
?
What battery size fits the Gehl RT185?
Quick answer
Group 31. Best available fitment is based on closest same-brand/model-family match (R165); confirm tray dimensions, terminal layout, and serial number before ordering.
?
How many CCA does the Gehl RT185 need?
Quick answer
720 CCA. Best available fitment is based on closest same-brand/model-family match (R165); an equal-or-higher CCA replacement is acceptable if the physical size and terminals match.
?
What voltage battery does the Gehl RT185 use?
Quick answer
12 volts. Skid-steer starting/charging systems for this model family use a 12 V battery system; confirm serial-specific configuration before replacement.
?
Where is the battery on the Gehl RT185?
Quick answer
Family-match guidance: The battery on the Gehl RT175 skid steer loader is typically located under the operator's seat or behind an access panel on the rear of the machine. For replacement, use a battery with the same specifications as the original, commonly a 12-volt Group 24 or Group 27 deep-cycle battery. Verify the exact access panel/compartment for the machine serial number before service.
?
What is the best replacement battery for the Gehl RT185?
Quick answer
Use a heavy-duty 12 V starting battery in BCI Group 31 with about 720 CCA (or higher), provided the case dimensions, hold-down and terminal orientation match. AGM is a good upgrade for vibration resistance; verify the machine serial number before purchase.
Disclaimer: Battery specifications are for general reference and may vary by year, serial number or configuration. Always verify fitment and electrical requirements before purchase or installation. See the Gehl website for manufacturer information.
