Cub Cadet 514 Belt Size

Quick answer:

The deck belt size found is 80 in (2,032 mm) long by 0.5 in (13 mm) wide. The drive belt size found is 54 in (1,372 mm) long by 0.5 in (13 mm) wide.

Deck belt sizelength 80 in (2,032 mm) and width 0.5 in (13 mm)
Drive belt sizelength 54 in (1,372 mm) and width 0.5 in (13 mm)

Cub Cadet 514 Belt Size and Part Numbers

Mower deck belt length 80 in (2,032 mm)
Mower deck belt width 0.5 in (13 mm)
Drive belt length 54 in (1,372 mm)
Drive belt width 0.5 in (13 mm)

Belt Size Comparison Chart

Belt length comparison

This model

80 in

Average

75 in

Low

50 in

High

105 in

Belt width comparison

This model

0.5 in

Average

0.5 in

Low

0.38 in

High

0.75 in

Cub Cadet 514 Belt Notes

Mower deck belt note The Cub Cadet 514 deck belt measurement captured here is length 80 in (2,032 mm) and width 0.5 in (13 mm). Use the listed value as a buying guide, not a blind substitute for the deck-specific parts diagram
Drive belt note The Cub Cadet 514 drive or transmission belt measurement captured here is length 54 in (1,372 mm) and width 0.5 in (13 mm). This is separate from the mower deck belt
Fitment note The blunt rule with the Cub Cadet 514: part number beats guesswork. If the belt is off by even a small amount, it can slip, squeal, jump pulleys or wear fast

Cub Cadet 514 Belt Size FAQ

What should you watch when fitting a 80 in (2,032 mm) deck belt on the Cub Cadet 514?

A 80 in (2,032 mm) deck belt leaves little room for sloppy routing. This is a mid-length belt run, so routing and idler position still matter more than just matching a close-looking belt. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each keeper

Can you replace the Cub Cadet 514 belt with the same length but different width?

The deck belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right

Which Cub Cadet 514 belt needs more careful length matching?

The deck belt is longer here: deck 80 in (2,032 mm) versus drive 54 in (1,372 mm), about 26 in (660 mm) different. Do not cross-match them just because both are mower belts

Official information note

Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official cubcadet.com before ordering a replacement belt.