The Cub Cadet 2082 deck belt part number found is 754-04138. The deck belt size found is 96.5 in (2,451 mm) long by 0.62 in (16 mm) wide. The drive belt size found is 96.5 in (2,451 mm) long by 0.62 in (16 mm) wide.
Deck belt part #754-04138
Deck belt sizelength 96.5 in (2,451 mm) and width 0.62 in (16 mm)
Drive belt sizelength 96.5 in (2,451 mm) and width 0.62 in (16 mm)
Cub Cadet 2082 Belt Size and Part Numbers
Mower deck belt part number
754-04138
Mower deck belt length
96.5 in (2,451 mm)
Mower deck belt width
0.62 in (16 mm)
Drive belt length
96.5 in (2,451 mm)
Drive belt width
0.62 in (16 mm)
Belt Size Comparison Chart
Belt length comparison
This model
96 in
Average
110 in
Low
75 in
High
155 in
Belt width comparison
This model
0.62 in
Average
0.75 in
Low
0.5 in
High
1.25 in
Cub Cadet 2082 Belt Notes
Mower deck belt note
The Cub Cadet 2082 deck belt listing shows part number 754-04138, length 96.5 in (2,451 mm) and width 0.62 in (16 mm). Confirm the belt against the deck tag, belt decal or parts diagram before ordering
Drive belt note
The Cub Cadet 2082 drive or transmission belt measurement captured here is length 96.5 in (2,451 mm) and width 0.62 in (16 mm). Treat it as partial drive-belt data if no matching width or OEM part number is shown
Fitment note
For the Cub Cadet 2082, use the listed specs as a buying guide, but confirm against the operator manual, parts diagram or belt label before spending money
Cub Cadet 2082 Belt Size FAQ
What should you watch when fitting a 96.5 in (2,451 mm) deck belt on the Cub Cadet 2082?
A 96.5 in (2,451 mm) deck belt leaves little room for sloppy routing. This is a longer mower belt run, so twist, idler alignment and the belt keeper positions matter. A belt can be the right length and still fail if it is routed wrong. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of.
Should you buy the Cub Cadet 2082 belt by length only?
No. The deck belt width found is 0.62 in (16 mm). That is wider than many light mower belts, so do not replace it with a thinner belt just because the length is close. It may sit too low in the pulley and slip. Use length, width and OEM part number together where possible
Official information note
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official cubcadet.com before ordering a replacement belt.
