The deck belt size found is 101 in (2,565 mm) long by 0.62 in (16 mm) wide. The drive belt part number found is 754-0468. The drive belt size found is 95 in (2,413 mm) long by 0.5 in (13 mm) wide.
Cub Cadet 1180 Belt Size and Part Numbers
| Mower deck belt length | 101 in (2,565 mm) |
|---|---|
| Mower deck belt width | 0.62 in (16 mm) |
| Drive belt part number | 754-0468 |
| Drive belt length | 95 in (2,413 mm) |
| Drive belt width | 0.5 in (13 mm) |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
Cub Cadet 1180 Belt Notes
| Mower deck belt note | The Cub Cadet 1180 deck belt measurement captured here is length 101 in (2,565 mm) and width 0.62 in (16 mm). Use the listed value as a buying guide, not a blind substitute for the deck-specific parts diagram |
|---|---|
| Drive belt note | The Cub Cadet 1180 drive or transmission belt listing shows part number 754-0468, length 95 in (2,413 mm) and width 0.5 in (13 mm). This is separate from the mower deck belt |
| Fitment note | The blunt rule with the Cub Cadet 1180: part number beats guesswork. If the belt is off by even a small amount, it can slip, squeal, jump pulleys or wear fast |
Cub Cadet 1180 Belt Size FAQ
What should you watch when fitting a 101 in (2,565 mm) deck belt on the Cub Cadet 1180?
A 101 in (2,565 mm) deck belt leaves little room for sloppy routing. This is a longer mower belt run, so twist, idler alignment and the belt keeper positions matter. A belt can be the right length and still fail if it is routed wrong. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each.
Can you replace the Cub Cadet 1180 belt with the same length but different width?
The deck belt width found is 0.62 in (16 mm). That is wider than many light mower belts, so do not replace it with a thinner belt just because the length is close. It may sit too low in the pulley and slip. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right
Which Cub Cadet 1180 belt needs more careful length matching?
The deck belt is longer here: deck 101 in (2,565 mm) versus drive 95 in (2,413 mm), about 6 in (152 mm) different. Do not cross-match them just because both are mower belts
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official cubcadet.com before ordering a replacement belt.
