The Case SR160B skid-steer battery size is Group 31, and it uses a 12-volt electrical system. Its 750 CCA rating is average for Case skid-steers in this dataset.
ModelSR160B
BrandCase
Voltage12 V
EquipmentSkid Steer
Voltage
12 V
Cold cranking
750 CCA
Battery size
Group 31
Battery location
See details below
How this battery compares
Compared with other Case skid-steer battery ratings in this dataset.
Cold cranking amps750 CCA
Average
LowAverageHigh
Low 185 CCAMedian 800 CCAHigh 1835 CCA
BA
Battery specification
Model-specific replacement data
System voltage
12 V
Battery group size
Group 31
Cold cranking amps
750 CCA
RP
Replacement battery
What to match when buying
The best replacement battery for a Case SR160B skid steer loader is typically a 12-volt battery with a minimum of 650 CCA (Cold Cranking Amps). It's important to check the specific model requirements and consult with a battery supplier for the exact fit.
LC
Battery location
Where the battery is mounted
Family-match guidance: The battery on the Case SR210B skid steer loader is located at the rear of the machine, where all regular service points and checks are grouped. Verify the exact access panel/compartment for the machine serial number before service.
ID
Model details
Equipment identity
Brand
Case
Model
SR160B
Equipment class
Skid-Steer Loader
HOW
How to replace the battery
Basic replacement procedure
Park on level ground, lower the lift arms/attachment, stop the engine, remove the key and isolate electrical power. Open the battery access, disconnect the negative cable first and then positive, remove the hold-down and lift out the battery. Clean the tray/terminals, install the replacement securely, connect positive first and negative last, then verify charging voltage and starting operation.
!
Bad battery symptoms
Signs the battery may be failing
Common symptoms of a bad battery in a Case SR160B skid steer loader include failure to start, intermittent starting issues, and dim or flickering lights. For battery specifications and replacement details, refer to the Case parts manuals.
?
What battery size fits the Case SR160B?
Quick answer
Group 31. Best available fitment is based on closest same-brand/model-family match (SR130B); confirm tray dimensions, terminal layout, and serial number before ordering.
?
How many CCA does the Case SR160B need?
Quick answer
750 CCA. Best available fitment is based on closest same-brand/model-family match (SR130B); an equal-or-higher CCA replacement is acceptable if the physical size and terminals match.
?
What voltage battery does the Case SR160B use?
Quick answer
The official battery voltage for the Case SR160B skid steer loader is 12 volts. For replacement, it's important to check the specific model requirements to ensure compatibility.
?
Where is the battery on the Case SR160B?
Quick answer
Family-match guidance: The battery on the Case SR210B skid steer loader is located at the rear of the machine, where all regular service points and checks are grouped. Verify the exact access panel/compartment for the machine serial number before service.
?
What is the best replacement battery for the Case SR160B?
Quick answer
The best replacement battery for a Case SR160B skid steer loader is typically a 12-volt battery with a minimum of 650 CCA (Cold Cranking Amps). It's important to check the specific model requirements and consult with a battery supplier for the exact fit.
Disclaimer: Battery specifications are for general reference and may vary by year, serial number or configuration. Always verify fitment and electrical requirements before purchase or installation. See the Case website for manufacturer information.
