The Case IH MX200 tractor cooling system capacity is 45.5 gal | 172.2 L, coolant type is extended-life OAT coolant, and coolant change interval is every 6,000 hours or 6 years.
Case IH MX200 Coolant Capacity Details
Cooling system capacity
45.5 gal | 172.2 L
Coolant type
Extended-life OAT coolant
Coolant change interval
Every 6,000 hours or 6 years
Radiator cap pressure
13.1 psi | 90 kPa
Coolant Capacity Comparison Chart
Coolant Capacity Comparison
This model
45.5 gal
Average
10 gal
Low
6 gal
High
16 gal
Benchmarks use practical low, average and high coolant-capacity ranges for the row-crop tractor category. Use the exact tractor manual before buying coolant.
Case IH MX200 Extra Coolant Notes
Engine horsepower
165 hp | 123 kW
Engine displacement
8.3 L | 504.5 cu in
Capacity note
For the Case IH MX200, the listed cooling system capacity is 45.5 gal | 172.2 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note
Use the coolant type listed above and match the antifreeze/water mix to the operator manual and local freezing conditions.
Radiator cap note
The radiator cap pressure listed for the Case IH MX200 is 13.1 psi | 90 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note
Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.
Case IH MX200 Coolant FAQs
How much coolant does a Case IH MX200 take?
The Case IH MX200 takes 45.5 gal | 172.2 L of coolant. That is well above the normal row-crop tractor benchmark shown here, so treat it as a full cooling-system service job, not a quick top-up.
Is 45.5 gal | 172.2 L a lot of coolant for a Case IH MX200?
Yes. For this tractor category, 45.5 gal | 172.2 L is well above normal. This is the sort of refill where you want all coolant on hand before draining, because stopping halfway through the job is annoying and messy.
How many coolant jugs do I need for a Case IH MX200?
Do not underestimate this refill. A 45.5 gal | 172.2 L system needs about 46 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 22.8 gal of concentrate and 22.8 gal of distilled water. In metric terms, that is roughly 35 x 5 L containers for a full premix refill.
Can I mix coolant types in a Case IH MX200?
Because the listed coolant is extended-life OAT coolant, the clean move is to stay with the same approved chemistry. Do not casually mix it with old green conventional coolant; if the old coolant type is unknown, flush first or confirm what is already in the system.
Can I use a different radiator cap on a Case IH MX200?
The listed cap pressure is 13.1 psi | 90 kPa. That higher-pressure cap helps raise the boiling point, but only if the radiator neck, hoses and overflow path are in good shape. A weak cap or damaged seat can still cause coolant loss.
When should the Case IH MX200 coolant be changed?
Use whichever limit comes first for the Case IH MX200: every 6,000 hours or 6 years. Low-hour tractors can still age out on time, because corrosion protection gets weaker even when the coolant still looks clean.
Official information note
Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official caseih.com website before draining, flushing or refilling the cooling system.
