The deck belt size found is 79 in (2,007 mm) long by 0.38 in (10 mm) wide. The drive belt width found is 0.5 in (13 mm).
Cub Cadet 1450 Belt Size and Part Numbers
| Mower deck belt length | 79 in (2,007 mm) |
|---|---|
| Mower deck belt width | 0.38 in (10 mm) |
| Drive belt width | 0.5 in (13 mm) |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
Cub Cadet 1450 Belt Notes
| Mower deck belt note | The Cub Cadet 1450 deck belt measurement captured here is length 79 in (2,007 mm) and width 0.38 in (10 mm). Use the listed value as a buying guide, not a blind substitute for the deck-specific parts diagram |
|---|---|
| Drive belt note | The Cub Cadet 1450 drive or transmission belt measurement captured here is width 0.5 in (13 mm). This is separate from the mower deck belt |
| Fitment note | The blunt rule with the Cub Cadet 1450: part number beats guesswork. If the belt is off by even a small amount, it can slip, squeal, jump pulleys or wear fast |
Cub Cadet 1450 Belt Size FAQ
Is a close belt length good enough for the Cub Cadet 1450 deck?
The deck belt length found is 79 in (2,007 mm). Close is not the same as correct. A belt that is slightly short can overload bearings, while one slightly long can slip or fail to engage the blades cleanly
Can you replace the Cub Cadet 1450 belt with the same length but different width?
The deck belt width found is 0.38 in (10 mm). That is a narrow belt, so do not casually swap in a 1/2-inch belt unless the parts diagram says it crosses over. Too-wide belts can ride high in the pulley. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official cubcadet.com before ordering a replacement belt.
