The deck belt size found is 80 in (2,032 mm) long by 0.5 in (13 mm) wide. The drive belt size found is 95 in (2,413 mm) long by 0.5 in (13 mm) wide.
Cub Cadet 1300 Belt Size and Part Numbers
| Mower deck belt length | 80 in (2,032 mm) |
|---|---|
| Mower deck belt width | 0.5 in (13 mm) |
| Drive belt length | 95 in (2,413 mm) |
| Drive belt width | 0.5 in (13 mm) |
| Deck size | 54 in deck |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
Mower deck size comparison
Cub Cadet 1300 Belt Notes
| Mower deck belt note | The Cub Cadet 1300 deck belt measurement captured here is length 80 in (2,032 mm) and width 0.5 in (13 mm). Use the listed value as a buying guide, not a blind substitute for the deck-specific parts diagram |
|---|---|
| Drive belt note | The Cub Cadet 1300 drive or transmission belt measurement captured here is length 95 in (2,413 mm) and width 0.5 in (13 mm). This is separate from the mower deck belt |
| Deck size note | The captured mower deck size for the Cub Cadet 1300 is 54 in deck. Deck size matters because the same model family can use different belts with different decks |
| Fitment note | For the Cub Cadet 1300, use the listed specs as a buying guide, but confirm against the operator manual, parts diagram or belt label before spending money |
Cub Cadet 1300 Belt Size FAQ
What should you watch when fitting a 80 in (2,032 mm) deck belt on the Cub Cadet 1300?
A 80 in (2,032 mm) deck belt leaves little room for sloppy routing. This is a mid-length belt run, so routing and idler position still matter more than just matching a close-looking belt. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each keeper
Can you replace the Cub Cadet 1300 belt with the same length but different width?
The deck belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right
Which Cub Cadet 1300 belt needs more careful length matching?
The drive belt is longer here: deck 80 in (2,032 mm) versus drive 95 in (2,413 mm), about 15 in (381 mm) different. Do not cross-match them just because both are mower belts
What is the fastest way to confirm the Cub Cadet 1300 deck belt?
Start with the captured 54 in deck deck and the deck belt value 80 in (2,032 mm). Then check the belt routing decal or parts diagram so you do not order a belt for the wrong deck
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official cubcadet.com before ordering a replacement belt.
