Cub Cadet 804 Belt Size

Quick answer:

The Cub Cadet 804 deck belt part number found is 954-04240. The deck belt size found is 75.5 in (1,918 mm) long by 0.38 in (10 mm) wide. The drive belt size found is 75.5 in (1,918 mm) long by 0.38 in (10 mm) wide.

Deck belt part #954-04240
Deck belt sizelength 75.5 in (1,918 mm) and width 0.38 in (10 mm)
Drive belt sizelength 75.5 in (1,918 mm) and width 0.38 in (10 mm)

Cub Cadet 804 Belt Size and Part Numbers

Mower deck belt part number 954-04240
Mower deck belt length 75.5 in (1,918 mm)
Mower deck belt width 0.38 in (10 mm)
Drive belt length 75.5 in (1,918 mm)
Drive belt width 0.38 in (10 mm)

Belt Size Comparison Chart

Belt length comparison

This model

76 in

Average

75 in

Low

50 in

High

105 in

Belt width comparison

This model

0.38 in

Average

0.38 in

Low

0.25 in

High

0.5 in

Cub Cadet 804 Belt Notes

Mower deck belt note The Cub Cadet 804 deck belt listing shows part number 954-04240, length 75.5 in (1,918 mm) and width 0.38 in (10 mm). Confirm the belt against the deck tag, belt decal or parts diagram before ordering
Drive belt note The Cub Cadet 804 drive or transmission belt measurement captured here is length 75.5 in (1,918 mm) and width 0.38 in (10 mm). Treat it as partial drive-belt data if no matching width or OEM part number is shown
Fitment note For the Cub Cadet 804, use the listed specs as a buying guide, but confirm against the operator manual, parts diagram or belt label before spending money

Cub Cadet 804 Belt Size FAQ

What should you watch when fitting a 75.5 in (1,918 mm) deck belt on the Cub Cadet 804?

A 75.5 in (1,918 mm) deck belt leaves little room for sloppy routing. This is a mid-length belt run, so routing and idler position still matter more than just matching a close-looking belt. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each keeper

Should you buy the Cub Cadet 804 belt by length only?

No. The deck belt width found is 0.38 in (10 mm). That is a narrow belt, so do not casually swap in a 1/2-inch belt unless the parts diagram says it crosses over. Too-wide belts can ride high in the pulley. Use length, width and OEM part number together where possible

Official information note

Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official cubcadet.com before ordering a replacement belt.