The John Deere 60 deck belt part number found is M144202. The deck belt size found is 88 in (2,235 mm) long by 0.5 in (13 mm) wide.
John Deere 60 Belt Size and Part Numbers
| Mower deck belt part number | M144202 |
|---|---|
| Mower deck belt length | 88 in (2,235 mm) |
| Mower deck belt width | 0.5 in (13 mm) |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
John Deere 60 Belt Notes
| Mower deck belt note | The John Deere 60 deck belt listing shows part number M144202, length 88 in (2,235 mm) and width 0.5 in (13 mm). Use the listed value as a buying guide, not a blind substitute for the deck-specific parts diagram |
|---|---|
| Fitment note | Before ordering a John Deere 60 belt, compare the old belt routing, pulley layout and deck size if available. A close-looking belt can still be wrong |
John Deere 60 Belt Size FAQ
Is a close belt length good enough for the John Deere 60 deck?
The deck belt length found is 88 in (2,235 mm). Close is not the same as correct. A belt that is slightly short can overload bearings, while one slightly long can slip or fail to engage the blades cleanly
Can you replace the John Deere 60 belt with the same length but different width?
The deck belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official John Deere parts catalog before ordering a replacement belt.
