The Massey Ferguson 7724S tractor cooling system capacity is 4.1 gal | 15.5 L and coolant type is 50/50 ethylene glycol-based coolant.
Massey Ferguson 7724S Coolant Capacity Details
Cooling system capacity
4.1 gal | 15.5 L
Coolant type
50/50 ethylene glycol-based coolant
Coolant mixture ratio
The recommended coolant mixture ratio for a Massey Ferguson 7724S tractor is typically 50% antifreeze and 50% water
Radiator cap pressure
10.2 psi | 70 kPa
Coolant Capacity Comparison Chart
Coolant Capacity Comparison
This model
4.1 gal
Average
5.5 gal
Low
3 gal
High
9 gal
Benchmarks use practical low, average and high coolant-capacity ranges for the utility tractor category. Use the exact tractor manual before buying coolant.
Massey Ferguson 7724S Extra Coolant Notes
Engine horsepower
220 hp | 164.1 kW
Engine displacement
7.4 L | 450 cu in
Capacity note
For the Massey Ferguson 7724S, the listed cooling system capacity is 4.1 gal | 15.5 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note
The recommended coolant mixture ratio for a Massey Ferguson 7724S tractor is typically 50% antifreeze and 50% water.
Radiator cap note
The radiator cap pressure listed for the Massey Ferguson 7724S is 10.2 psi | 70 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note
Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.
Massey Ferguson 7724S Coolant FAQs
How much coolant does a Massey Ferguson 7724S take?
The Massey Ferguson 7724S takes 4.1 gal | 15.5 L of coolant. That is below the average utility tractor benchmark, so it is not a huge coolant job, but you still want spare premix for topping off.
Is 4.1 gal | 15.5 L a small coolant capacity for a Massey Ferguson 7724S?
It is below average compared with the benchmark on this page. That makes the job cheaper, but it does not make coolant choice or bleeding less important.
How many coolant jugs do I need for a Massey Ferguson 7724S?
This is a manageable refill amount. A 4.1 gal | 15.5 L system needs about 5 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 2 gal of concentrate and 2 gal of distilled water. In metric terms, that is roughly 4 x 5 L containers for a full premix refill.
What coolant should I use in a Massey Ferguson 7724S?
The listed coolant is 50/50 ethylene glycol-based coolant. Ethylene glycol tells you the base coolant, but the additive package still matters on diesel engines, so match the manual or an approved equivalent. The listed mix is the recommended coolant mixture ratio for a Massey Ferguson 7724S tractor is typically 50% antifreeze and 50% water, so do not run straight water except as a short emergency move.
How much concentrate and water does a Massey Ferguson 7724S need?
With the listed the recommended coolant mixture ratio for a Massey Ferguson 7724S tractor is typically 50% antifreeze and 50% water mix, a full 4.1 gal | 15.5 L refill works out to about 2 gal of antifreeze concentrate and 2 gal of distilled water. If using premix, do not add extra water unless the product label says to.
Can I use a different radiator cap on a Massey Ferguson 7724S?
The listed cap pressure is 10.2 psi | 70 kPa. Use the same pressure rating when replacing it. The cap is part of the cooling system, not just a lid, and the wrong rating can cause boil-over, leaks or pressure problems.
Official information note
Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official masseyferguson.com website before draining, flushing or refilling the cooling system.
