The Massey Ferguson 3050 tractor cooling system capacity is 39 gal | 147.6 L and coolant change interval is every 6,000 hours or 6 years.
Massey Ferguson 3050 Coolant Capacity Details
Cooling system capacity
39 gal | 147.6 L
Coolant change interval
Every 6,000 hours or 6 years
Coolant mixture ratio
50/50 antifreeze and water
Radiator cap pressure
13 psi | 90 kPa
Coolant Capacity Comparison Chart
Coolant Capacity Comparison
This model
39 gal
Average
5.5 gal
Low
3 gal
High
9 gal
Benchmarks use practical low, average and high coolant-capacity ranges for the utility tractor category. Use the exact tractor manual before buying coolant.
Massey Ferguson 3050 Extra Coolant Notes
Engine horsepower
68 hp | 50.7 kW
Engine displacement
3.9 L | 239 cu in
Capacity note
For the Massey Ferguson 3050, the listed cooling system capacity is 39 gal | 147.6 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note
50/50 antifreeze and water.
Radiator cap note
The radiator cap pressure listed for the Massey Ferguson 3050 is 13 psi | 90 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note
Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.
Massey Ferguson 3050 Coolant FAQs
How much coolant does a Massey Ferguson 3050 take?
The Massey Ferguson 3050 takes 39 gal | 147.6 L of coolant. That is well above the normal utility tractor benchmark shown here, so treat it as a full cooling-system service job, not a quick top-up.
Is 39 gal | 147.6 L a lot of coolant for a Massey Ferguson 3050?
Yes. For this tractor category, 39 gal | 147.6 L is well above normal. This is the sort of refill where you want all coolant on hand before draining, because stopping halfway through the job is annoying and messy.
How many coolant jugs do I need for a Massey Ferguson 3050?
Do not underestimate this refill. A 39 gal | 147.6 L system needs about 39 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 19.5 gal of concentrate and 19.5 gal of distilled water. In metric terms, that is roughly 30 x 5 L containers for a full premix refill.
How much concentrate and water does a Massey Ferguson 3050 need?
With the listed 50/50 antifreeze and water mix, a full 39 gal | 147.6 L refill works out to about 19.5 gal of antifreeze concentrate and 19.5 gal of distilled water. If using premix, do not add extra water unless the product label says to.
Can I use a different radiator cap on a Massey Ferguson 3050?
The listed cap pressure is 13 psi | 90 kPa. That higher-pressure cap helps raise the boiling point, but only if the radiator neck, hoses and overflow path are in good shape. A weak cap or damaged seat can still cause coolant loss.
When should the Massey Ferguson 3050 coolant be changed?
Use whichever limit comes first for the Massey Ferguson 3050: every 6,000 hours or 6 years. Low-hour tractors can still age out on time, because corrosion protection gets weaker even when the coolant still looks clean.
Official information note
Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official masseyferguson.com website before draining, flushing or refilling the cooling system.
