The Massey Ferguson 2645 tractor cooling system capacity is 56.3 gal | 213.1 L, coolant type is 50/50 ethylene glycol-based coolant, and coolant change interval is every 600 hours.
Massey Ferguson 2645 Coolant Capacity Details
Cooling system capacity
56.3 gal | 213.1 L
Coolant type
50/50 ethylene glycol-based coolant
Coolant change interval
Every 600 hours
Radiator cap pressure
10 psi | 70 kPa
Coolant Capacity Comparison Chart
Coolant Capacity Comparison
This model
56.3 gal
Average
10 gal
Low
6 gal
High
16 gal
Benchmarks use practical low, average and high coolant-capacity ranges for the row-crop tractor category. Use the exact tractor manual before buying coolant.
Massey Ferguson 2645 Extra Coolant Notes
Engine horsepower
110 hp | 82 kW
Engine displacement
5.8 L | 353.6 cu in
Capacity note
For the Massey Ferguson 2645, the listed cooling system capacity is 56.3 gal | 213.1 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note
Use the coolant type listed above and match the antifreeze/water mix to the operator manual and local freezing conditions.
Radiator cap note
The radiator cap pressure listed for the Massey Ferguson 2645 is 10 psi | 70 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note
Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.
Massey Ferguson 2645 Coolant FAQs
How much coolant does a Massey Ferguson 2645 take?
The Massey Ferguson 2645 takes 56.3 gal | 213.1 L of coolant. That is well above the normal row-crop tractor benchmark shown here, so treat it as a full cooling-system service job, not a quick top-up.
Is 56.3 gal | 213.1 L a lot of coolant for a Massey Ferguson 2645?
Yes. For this tractor category, 56.3 gal | 213.1 L is well above normal. This is the sort of refill where you want all coolant on hand before draining, because stopping halfway through the job is annoying and messy.
How many coolant jugs do I need for a Massey Ferguson 2645?
Do not underestimate this refill. A 56.3 gal | 213.1 L system needs about 57 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 28.1 gal of concentrate and 28.1 gal of distilled water. In metric terms, that is roughly 43 x 5 L containers for a full premix refill.
What coolant should I use in a Massey Ferguson 2645?
The listed coolant is 50/50 ethylene glycol-based coolant. Ethylene glycol tells you the base coolant, but the additive package still matters on diesel engines, so match the manual or an approved equivalent.
Can I use a different radiator cap on a Massey Ferguson 2645?
The listed cap pressure is 10 psi | 70 kPa. Use the same pressure rating when replacing it. The cap is part of the cooling system, not just a lid, and the wrong rating can cause boil-over, leaks or pressure problems.
When should the Massey Ferguson 2645 coolant be changed?
The listed interval is every 600 hours. Hour-based service matters most on working tractors that spend long periods hot under load.
Official information note
Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official masseyferguson.com website before draining, flushing or refilling the cooling system.
