The Massey Ferguson 1E.25 tractor cooling system capacity is 2.5 gal | 9.5 L and coolant type is the Massey Ferguson 1E.25 tractor uses a Long Life Coolant (LLC) or Extended Life Coolant (ELC) that meets standards such as ASTM D6210, D4985, JIS K-2234, SAE J814C, J1941,.
Massey Ferguson 1E.25 Coolant Capacity Details
| Cooling system capacity | 2.5 gal | 9.5 L |
|---|---|
| Coolant type | The Massey Ferguson 1E.25 tractor uses a Long Life Coolant (LLC) or Extended Life Coolant (ELC) that meets standards such as ASTM D6210, D4985, JIS K-2234, SAE J814C, J1941, |
| Coolant mixture ratio | The recommended coolant mixture ratio for a Massey Ferguson tractor, including the 1E.25 model, is typically 50% antifreeze and 50% water |
| Radiator cap pressure | 9 psi | 62 kPa |
Coolant Capacity Comparison Chart
Coolant Capacity Comparison
Benchmarks use practical low, average and high coolant-capacity ranges for the compact tractor category. Use the exact tractor manual before buying coolant.
Massey Ferguson 1E.25 Extra Coolant Notes
| Engine horsepower | 24 hp | 17.9 kW |
|---|---|
| Engine displacement | The Massey Ferguson 1E.25 compact tractor uses a 1.49-liter Iseki 3-cylinder diesel engine |
| Capacity note | For the Massey Ferguson 1E.25, the listed cooling system capacity is 2.5 gal | 9.5 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out. |
| Mixture note | The recommended coolant mixture ratio for a Massey Ferguson tractor, including the 1E.25 model, is typically 50% antifreeze and 50% water. |
| Radiator cap note | The radiator cap pressure listed for the Massey Ferguson 1E.25 is 9 psi | 62 kPa. Do not replace it with a random cap unless the pressure rating matches. |
| Refill note | Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure. |
Massey Ferguson 1E.25 Coolant FAQs
How much coolant does a Massey Ferguson 1E.25 take?
The Massey Ferguson 1E.25 takes 2.5 gal | 9.5 L of coolant. That is about normal for the compact tractor benchmark shown here, so plan it like a standard drain-and-refill rather than a tiny top-up.
Is the Massey Ferguson 1E.25 coolant capacity normal?
Yes, 2.5 gal | 9.5 L lands about where you would expect for this tractor category. The main thing is buying enough for a complete refill plus a small top-off amount.
How many coolant jugs do I need for a Massey Ferguson 1E.25?
This is a manageable refill amount. A 2.5 gal | 9.5 L system needs about 3 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 1.2 gal of concentrate and 1.2 gal of distilled water. In metric terms, that is roughly 2 x 5 L containers for a full premix refill.
What coolant should I use in a Massey Ferguson 1E.25?
Use the Massey Ferguson 1E.25 tractor uses a Long Life Coolant (LLC) or Extended Life Coolant (ELC) that meets standards such as ASTM D6210, D4985, JIS K-2234, SAE J814C, J1941, as the starting point, then match the exact manual spec before buying. The risky shortcut is mixing coolants by color alone, because color does not reliably prove the chemistry. The listed mix is the recommended coolant mixture ratio for a Massey Ferguson tractor, including the 1E.25 model, is typically 50% antifreeze and 50% water, so do not run straight water except as a short emergency move.
How much concentrate and water does a Massey Ferguson 1E.25 need?
With the listed the recommended coolant mixture ratio for a Massey Ferguson tractor, including the 1E.25 model, is typically 50% antifreeze and 50% water mix, a full 2.5 gal | 9.5 L refill works out to about 1.2 gal of antifreeze concentrate and 1.2 gal of distilled water. If using premix, do not add extra water unless the product label says to.
Can I use a different radiator cap on a Massey Ferguson 1E.25?
The listed cap pressure is 9 psi | 62 kPa. Use the same pressure rating when replacing it. The cap is part of the cooling system, not just a lid, and the wrong rating can cause boil-over, leaks or pressure problems.
Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official masseyferguson.com website before draining, flushing or refilling the cooling system.
