The Massey Ferguson 1825E tractor cooling system capacity is 5.5 gal | 20.8 L and coolant change interval is every 500 hours.
Massey Ferguson 1825E Coolant Capacity Details
Cooling system capacity
5.5 gal | 20.8 L
Coolant change interval
Every 500 hours
Coolant mixture ratio
50/50 antifreeze and water
Radiator cap pressure
7 psi | 48.3 kPa
Coolant Capacity Comparison Chart
Coolant Capacity Comparison
This model
5.5 gal
Average
2.8 gal
Low
1.5 gal
High
5 gal
Benchmarks use practical low, average and high coolant-capacity ranges for the compact tractor category. Use the exact tractor manual before buying coolant.
Massey Ferguson 1825E Extra Coolant Notes
Engine horsepower
24 hp | 17.9 kW
Engine displacement
1.5 L | 91.5 cu in
Capacity note
For the Massey Ferguson 1825E, the listed cooling system capacity is 5.5 gal | 20.8 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note
50/50 antifreeze and water.
Radiator cap note
The radiator cap pressure listed for the Massey Ferguson 1825E is 7 psi | 48.3 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note
Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.
Massey Ferguson 1825E Coolant FAQs
How much coolant does a Massey Ferguson 1825E take?
The Massey Ferguson 1825E takes 5.5 gal | 20.8 L of coolant. That is above the average compact tractor benchmark, so buy enough coolant before starting instead of relying on one spare jug.
Is 5.5 gal | 20.8 L a lot of coolant for a Massey Ferguson 1825E?
Yes. For this tractor category, 5.5 gal | 20.8 L is above average. This is the sort of refill where you want all coolant on hand before draining, because stopping halfway through the job is annoying and messy.
How many coolant jugs do I need for a Massey Ferguson 1825E?
This is more than a small top-off job. A 5.5 gal | 20.8 L system needs about 6 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 2.8 gal of concentrate and 2.8 gal of distilled water. In metric terms, that is roughly 5 x 5 L containers for a full premix refill.
How much concentrate and water does a Massey Ferguson 1825E need?
With the listed 50/50 antifreeze and water mix, a full 5.5 gal | 20.8 L refill works out to about 2.8 gal of antifreeze concentrate and 2.8 gal of distilled water. If using premix, do not add extra water unless the product label says to.
Can I use a different radiator cap on a Massey Ferguson 1825E?
The listed cap pressure is 7 psi | 48.3 kPa. That is a lower-pressure cap, so do not upgrade it to a higher-pressure cap just because it sounds stronger. Too much cap pressure can stress hoses, radiator seams and older seals.
When should the Massey Ferguson 1825E coolant be changed?
The listed interval is every 500 hours. Hour-based service matters most on working tractors that spend long periods hot under load.
Official information note
Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official masseyferguson.com website before draining, flushing or refilling the cooling system.
