The Gehl V330 skid-steer battery size is Group 31, and it uses a 12-volt electrical system. Its 950 CCA rating is high for Gehl skid-steers in this dataset.
ModelV330
BrandGehl
Voltage12 V
EquipmentSkid Steer
Voltage
12 V
Cold cranking
950 CCA
Battery size
Group 31
Battery location
See details below
How this battery compares
Compared with other Gehl skid-steer battery ratings in this dataset.
Cold cranking amps950 CCA
High
LowAverageHigh
Low 105 CCAMedian 800 CCAHigh 950 CCA
BA
Battery specification
Model-specific replacement data
System voltage
12 V
Battery group size
Group 31
Cold cranking amps
950 CCA
RP
Replacement battery
What to match when buying
The Gehl V330 skid steer loader typically requires a 12-volt battery with 950 cold cranking amps (CCA). It's advisable to use a group 31 battery, which is common for this type of equipment.
LC
Battery location
Where the battery is mounted
The battery on the Gehl V330 skid steer loader is typically located under the seat or in the rear compartment of the machine. For specific battery specifications and replacement options, it's best to consult the owner's manual or contact your local Gehl dealer.
ID
Model details
Equipment identity
Brand
Gehl
Model
V330
Equipment class
Skid-Steer Loader
HOW
How to replace the battery
Basic replacement procedure
Park on level ground, lower the lift arms/attachment, stop the engine, remove the key and isolate electrical power. Open the battery access, disconnect the negative cable first and then positive, remove the hold-down and lift out the battery. Clean the tray/terminals, install the replacement securely, connect positive first and negative last, then verify charging voltage and starting operation.
!
Bad battery symptoms
Signs the battery may be failing
Common signs are slow or no cranking, repeated clicking from the starter/solenoid, dim or flickering lights/display, electronics resetting during crank, needing frequent jump-starts, rapid self-discharge, corroded/swollen battery case, or resting voltage that quickly falls under load. Confirm cable condition and alternator output before condemning the battery.
?
What battery size fits the Gehl V330?
Quick answer
The official battery group size for the Gehl V330 skid steer loader is typically Group 31, which is commonly used for heavy equipment. For specific replacement options, it's best to consult the manufacturer's specifications or a parts supplier.
?
How many CCA does the Gehl V330 need?
Quick answer
950 CCA. Best available fitment is based on closest same-brand/model-family match (V420); an equal-or-higher CCA replacement is acceptable if the physical size and terminals match.
?
What voltage battery does the Gehl V330 use?
Quick answer
12 volts. Skid-steer starting/charging systems for this model family use a 12 V battery system; confirm serial-specific configuration before replacement.
?
Where is the battery on the Gehl V330?
Quick answer
The battery on the Gehl V330 skid steer loader is typically located under the seat or in the rear compartment of the machine. For specific battery specifications and replacement options, it's best to consult the owner's manual or contact your local Gehl dealer.
?
What is the best replacement battery for the Gehl V330?
Quick answer
The Gehl V330 skid steer loader typically requires a 12-volt battery with 950 cold cranking amps (CCA). It's advisable to use a group 31 battery, which is common for this type of equipment.
Disclaimer: Battery specifications are for general reference and may vary by year, serial number or configuration. Always verify fitment and electrical requirements before purchase or installation. See the Gehl website for manufacturer information.
