The drive belt part number found is 754-04060. The drive belt size found is 85 in (2,159 mm) long by 0.62 in (16 mm) wide.
Cub Cadet 100 Belt Size and Part Numbers
| Drive belt part number | 754-04060 |
|---|---|
| Drive belt length | 85 in (2,159 mm) |
| Drive belt width | 0.62 in (16 mm) |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
Cub Cadet 100 Belt Notes
| Drive belt note | The Cub Cadet 100 drive or transmission belt listing shows part number 754-04060, length 85 in (2,159 mm) and width 0.62 in (16 mm). This is separate from the mower deck belt |
|---|---|
| Fitment note | Belts are cheap until you buy the wrong one twice. On the Cub Cadet 100, confirm belt route, old belt label and OEM part number before ordering |
Cub Cadet 100 Belt Size FAQ
What should you check when fitting a 85 in (2,159 mm) drive belt on the Cub Cadet 100?
The drive belt length found is 85 in (2,159 mm). This is a mid-length belt run, so routing and idler position still matter more than just matching a close-looking belt. Also check the idler spring and pulley grooves because drive belts can slip under load even when they look fine at idle
Can you replace the Cub Cadet 100 belt with the same length but different width?
The drive belt width found is 0.62 in (16 mm). That is wider than many light mower belts, so do not replace it with a thinner belt just because the length is close. It may sit too low in the pulley and slip. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official cubcadet.com before ordering a replacement belt.
