The Case IH Steiger 435QT tractor cooling system capacity is 8.2 gal | 31 L and coolant type is extended-life OAT coolant.
Case IH Steiger 435QT Coolant Capacity Details
Cooling system capacity
8.2 gal | 31 L
Coolant type
Extended-life OAT coolant
Radiator cap pressure
13.1 psi | 90 kPa
Coolant Capacity Comparison Chart
Coolant Capacity Comparison
This model
8.2 gal
Average
10 gal
Low
6 gal
High
16 gal
Benchmarks use practical low, average and high coolant-capacity ranges for the row-crop tractor category. Use the exact tractor manual before buying coolant.
Case IH Steiger 435QT Extra Coolant Notes
Engine horsepower
435 hp | 324.4 kW
Engine displacement
12.9 L | 787 cu in
Capacity note
For the Case IH Steiger 435QT, the listed cooling system capacity is 8.2 gal | 31 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note
Use the coolant type listed above and match the antifreeze/water mix to the operator manual and local freezing conditions.
Radiator cap note
The radiator cap pressure listed for the Case IH Steiger 435QT is 13.1 psi | 90 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note
Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.
Case IH Steiger 435QT Coolant FAQs
How much coolant does a Case IH Steiger 435QT take?
The Case IH Steiger 435QT takes 8.2 gal | 31 L of coolant. That is about normal for the row-crop tractor benchmark shown here, so plan it like a standard drain-and-refill rather than a tiny top-up.
Is the Case IH Steiger 435QT coolant capacity normal?
Yes, 8.2 gal | 31 L lands about where you would expect for this tractor category. The main thing is buying enough for a complete refill plus a small top-off amount.
How many coolant jugs do I need for a Case IH Steiger 435QT?
This is more than a small top-off job. A 8.2 gal | 31 L system needs about 9 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 4.1 gal of concentrate and 4.1 gal of distilled water. In metric terms, that is roughly 7 x 5 L containers for a full premix refill.
Can I mix coolant types in a Case IH Steiger 435QT?
Because the listed coolant is extended-life OAT coolant, the clean move is to stay with the same approved chemistry. Do not casually mix it with old green conventional coolant; if the old coolant type is unknown, flush first or confirm what is already in the system.
Can I use a different radiator cap on a Case IH Steiger 435QT?
The listed cap pressure is 13.1 psi | 90 kPa. That higher-pressure cap helps raise the boiling point, but only if the radiator neck, hoses and overflow path are in good shape. A weak cap or damaged seat can still cause coolant loss.
Is the Case IH Steiger 435QT coolant capacity large for its engine?
The Case IH Steiger 435QT has 435 hp | 324.4 kW and 12.9 L | 787 cu in listed alongside a 8.2 gal | 31 L cooling system. That is a lean coolant volume for the horsepower figure, so clean fins, correct cap pressure and proper bleeding matter. Coolant capacity is not decided by displacement alone; the radiator, hoses, block passages and options all count.
Official information note
Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official caseih.com website before draining, flushing or refilling the cooling system.
