Case IH Puma 125 Coolant Capacity (4 gal)

Quick answer:

The Case IH Puma 125 tractor cooling system capacity is 4 gal | 15.1 L, coolant type is ethylene glycol-based coolant, and coolant change interval is every 5,000 hours or 5 years.

Case IH Puma 125 Coolant Capacity Details

Cooling system capacity 4 gal | 15.1 L
Coolant type Ethylene glycol-based coolant
Coolant change interval Every 5,000 hours or 5 years
Radiator cap pressure 13.1 psi | 90 kPa

Coolant Capacity Comparison Chart

Coolant Capacity Comparison

This model

4 gal

Average

5.5 gal

Low

3 gal

High

9 gal

Benchmarks use practical low, average and high coolant-capacity ranges for the utility tractor category. Use the exact tractor manual before buying coolant.

Case IH Puma 125 Extra Coolant Notes

Engine horsepower 125 hp
Engine displacement 6.7 L | 409 cu in
Capacity note For the Case IH Puma 125, the listed cooling system capacity is 4 gal | 15.1 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note Use the coolant type listed above and match the antifreeze/water mix to the operator manual and local freezing conditions.
Radiator cap note The radiator cap pressure listed for the Case IH Puma 125 is 13.1 psi | 90 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.

Case IH Puma 125 Coolant FAQs

How much coolant does a Case IH Puma 125 take?

The Case IH Puma 125 takes 4 gal | 15.1 L of coolant. That is below the average utility tractor benchmark, so it is not a huge coolant job, but you still want spare premix for topping off.

Is 4 gal | 15.1 L a small coolant capacity for a Case IH Puma 125?

It is below average compared with the benchmark on this page. That makes the job cheaper, but it does not make coolant choice or bleeding less important.

How many coolant jugs do I need for a Case IH Puma 125?

This is a manageable refill amount. A 4 gal | 15.1 L system needs about 4 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 2 gal of concentrate and 2 gal of distilled water. In metric terms, that is roughly 4 x 5 L containers for a full premix refill.

What coolant should I use in a Case IH Puma 125?

The listed coolant is ethylene glycol-based coolant. Ethylene glycol tells you the base coolant, but the additive package still matters on diesel engines, so match the manual or an approved equivalent.

Can I use a different radiator cap on a Case IH Puma 125?

The listed cap pressure is 13.1 psi | 90 kPa. That higher-pressure cap helps raise the boiling point, but only if the radiator neck, hoses and overflow path are in good shape. A weak cap or damaged seat can still cause coolant loss.

When should the Case IH Puma 125 coolant be changed?

Use whichever limit comes first for the Case IH Puma 125: every 5,000 hours or 5 years. Low-hour tractors can still age out on time, because corrosion protection gets weaker even when the coolant still looks clean.

Official information note

Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official caseih.com website before draining, flushing or refilling the cooling system.