The Case IH JX1060C tractor cooling system capacity is 5 gal | 19 L and coolant type is the Case IH JX1060C tractor uses OAT (Organic Acid Technology) antifreeze, which is specifically formulated for its cooling system.
Case IH JX1060C Coolant Capacity Details
Cooling system capacity
5 gal | 19 L
Coolant type
The Case IH JX1060C tractor uses OAT (Organic Acid Technology) antifreeze, which is specifically formulated for its cooling system
Coolant mixture ratio
50/50 antifreeze and water
Radiator cap pressure
10 psi | 68.9 kPa
Coolant Capacity Comparison Chart
Coolant Capacity Comparison
This model
5 gal
Average
5.5 gal
Low
3 gal
High
9 gal
Benchmarks use practical low, average and high coolant-capacity ranges for the utility tractor category. Use the exact tractor manual before buying coolant.
Case IH JX1060C Extra Coolant Notes
Engine horsepower
59 hp | 44 kW
Engine displacement
2.9 L | 178.8 cu in
Capacity note
For the Case IH JX1060C, the listed cooling system capacity is 5 gal | 19 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note
50/50 antifreeze and water.
Radiator cap note
The radiator cap pressure listed for the Case IH JX1060C is 10 psi | 68.9 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note
Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.
Case IH JX1060C Coolant FAQs
How much coolant does a Case IH JX1060C take?
The Case IH JX1060C takes 5 gal | 19 L of coolant. That is about normal for the utility tractor benchmark shown here, so plan it like a standard drain-and-refill rather than a tiny top-up.
Is the Case IH JX1060C coolant capacity normal?
Yes, 5 gal | 19 L lands about where you would expect for this tractor category. The main thing is buying enough for a complete refill plus a small top-off amount.
How many coolant jugs do I need for a Case IH JX1060C?
This is more than a small top-off job. A 5 gal | 19 L system needs about 5 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 2.5 gal of concentrate and 2.5 gal of distilled water. In metric terms, that is roughly 4 x 5 L containers for a full premix refill.
Can I mix coolant types in a Case IH JX1060C?
Because the listed coolant is the Case IH JX1060C tractor uses OAT (Organic Acid Technology) antifreeze, which is specifically formulated for its cooling system, the clean move is to stay with the same approved chemistry. Do not casually mix it with old green conventional coolant; if the old coolant type is unknown, flush first or confirm what is already in the system. The listed mix is 50/50 antifreeze and water, so do not run straight water except as a short emergency move.
How much concentrate and water does a Case IH JX1060C need?
With the listed 50/50 antifreeze and water mix, a full 5 gal | 19 L refill works out to about 2.5 gal of antifreeze concentrate and 2.5 gal of distilled water. If using premix, do not add extra water unless the product label says to.
Can I use a different radiator cap on a Case IH JX1060C?
The listed cap pressure is 10 psi | 68.9 kPa. Use the same pressure rating when replacing it. The cap is part of the cooling system, not just a lid, and the wrong rating can cause boil-over, leaks or pressure problems.
Official information note
Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official caseih.com website before draining, flushing or refilling the cooling system.
