The Case 1825 skid-steer battery size is Group 24, and it uses a 12-volt electrical system. Its 700 CCA rating is low for Case skid-steers in this dataset.
Model1825
BrandCase
Voltage12 V
EquipmentSkid Steer
Voltage
12 V
Cold cranking
700 CCA
Battery size
Group 24
Battery location
See details below
How this battery compares
Compared with other Case skid-steer battery ratings in this dataset.
Cold cranking amps700 CCA
Low
LowAverageHigh
Low 185 CCAMedian 800 CCAHigh 1835 CCA
BA
Battery specification
Model-specific replacement data
System voltage
12 V
Battery group size
Group 24
Cold cranking amps
700 CCA
RP
Replacement battery
What to match when buying
The Case 1825 Skid Steer Loader uses a 12-volt battery with a cold cranking amp (CCA) rating suitable for cold climates; AGM batteries are recommended for their vibration resistance and maintenance-free operation.
LC
Battery location
Where the battery is mounted
Family-match guidance: The battery on the Case 1825B skid steer loader is typically located under the floor panel near the rear of the machine, requiring removal of the floor to access it. Verify the exact access panel/compartment for the machine serial number before service.
ID
Model details
Equipment identity
Brand
Case
Model
1825
Equipment class
Skid-Steer Loader
HOW
How to replace the battery
Basic replacement procedure
Park on level ground, lower the lift arms/attachment, stop the engine, remove the key and isolate electrical power. Open the battery access, disconnect the negative cable first and then positive, remove the hold-down and lift out the battery. Clean the tray/terminals, install the replacement securely, connect positive first and negative last, then verify charging voltage and starting operation.
!
Bad battery symptoms
Signs the battery may be failing
Common symptoms of a bad battery in a Case 1825 skid steer loader include failure to start, intermittent starting issues, and dim or flickering lights. For battery specifications, it's important to check the Case operator’s manual for the correct size and capacity needed for replacement.
?
What battery size fits the Case 1825?
Quick answer
The official battery group size for the Case 1825 Skid Steer Loader is Group 24. For replacement, it's important to ensure the battery meets the specifications required for your specific model.
?
How many CCA does the Case 1825 need?
Quick answer
The recommended battery for the Case 1825B Skid Steer Loader typically has a Cold Cranking Amps (CCA) rating of around 650 to 700 CCA. It's important to ensure the battery fits properly and meets the specific requirements of your loader.
?
What voltage battery does the Case 1825 use?
Quick answer
The Case 1825 skid steer loader uses a 12-volt battery for starting and electrical systems.
?
Where is the battery on the Case 1825?
Quick answer
Family-match guidance: The battery on the Case 1825B skid steer loader is typically located under the floor panel near the rear of the machine, requiring removal of the floor to access it. Verify the exact access panel/compartment for the machine serial number before service.
?
What is the best replacement battery for the Case 1825?
Quick answer
The Case 1825 Skid Steer Loader uses a 12-volt battery with a cold cranking amp (CCA) rating suitable for cold climates; AGM batteries are recommended for their vibration resistance and maintenance-free operation.
Disclaimer: Battery specifications are for general reference and may vary by year, serial number or configuration. Always verify fitment and electrical requirements before purchase or installation. See the Case website for manufacturer information.
