The Gehl SL 4840 DXT skid-steer battery size should be verified for the specific machine, and it uses a 12-volt electrical system. Its 800 CCA rating is average for Gehl skid-steers in this dataset.
ModelSL 4840 DXT
BrandGehl
Voltage12 V
EquipmentSkid Steer
Voltage
12 V
Cold cranking
800 CCA
Battery size
Check physical fitment
Battery location
See details below
How this battery compares
Compared with other Gehl skid-steer battery ratings in this dataset.
Cold cranking amps800 CCA
Average
LowAverageHigh
Low 105 CCAMedian 800 CCAHigh 950 CCA
BA
Battery specification
Model-specific replacement data
System voltage
12 V
Battery group size
Check physical fitment
Cold cranking amps
800 CCA
RP
Replacement battery
What to match when buying
The best replacement battery for a Gehl SL 4840 DXT skid steer loader is a genuine Manitou Group Parts battery, available through your local GEHL dealer to ensure compatibility, warranty protection, and maximum productivity.
LC
Battery location
Where the battery is mounted
The battery on the Gehl SL 4840 DXT skid steer loader is typically located under the seat or in the rear compartment of the machine. For specific details, it's best to consult the owner's manual or contact your local GEHL dealer.
ID
Model details
Equipment identity
Brand
Gehl
Model
SL 4840 DXT
Equipment class
Skid-Steer Loader
HOW
How to replace the battery
Basic replacement procedure
Park on level ground, lower the lift arms/attachment, stop the engine, remove the key and isolate electrical power. Open the battery access, disconnect the negative cable first and then positive, remove the hold-down and lift out the battery. Clean the tray/terminals, install the replacement securely, connect positive first and negative last, then verify charging voltage and starting operation.
!
Bad battery symptoms
Signs the battery may be failing
Common signs are slow or no cranking, repeated clicking from the starter/solenoid, dim or flickering lights/display, electronics resetting during crank, needing frequent jump-starts, rapid self-discharge, corroded/swollen battery case, or resting voltage that quickly falls under load. Confirm cable condition and alternator output before condemning the battery.
?
What battery size fits the Gehl SL 4840 DXT?
Quick answer
The official battery group size for the Gehl SL 4840 DXT skid steer loader is not specified on; however, replacement batteries are available through NAPAonline for the Gehl Skid Steer Loader 4840 series.
?
How many CCA does the Gehl SL 4840 DXT need?
Quick answer
The recommended battery for the Gehl SL 4840 DXT skid steer loader typically has a Cold Cranking Amps (CCA) rating of around 650 to 800 CCA. For specific replacement options, it's best to consult the manufacturer's specifications or a local dealer.
?
What voltage battery does the Gehl SL 4840 DXT use?
Quick answer
The official battery voltage for the Gehl SL 4840 DXT skid steer loader is 12 volts. For replacement options, you can find compatible batteries at various equipment parts suppliers.
?
Where is the battery on the Gehl SL 4840 DXT?
Quick answer
The battery on the Gehl SL 4840 DXT skid steer loader is typically located under the seat or in the rear compartment of the machine. For specific details, it's best to consult the owner's manual or contact your local GEHL dealer.
?
What is the best replacement battery for the Gehl SL 4840 DXT?
Quick answer
The best replacement battery for a Gehl SL 4840 DXT skid steer loader is a genuine Manitou Group Parts battery, available through your local GEHL dealer to ensure compatibility, warranty protection, and maximum productivity.
Disclaimer: Battery specifications are for general reference and may vary by year, serial number or configuration. Always verify fitment and electrical requirements before purchase or installation. See the Gehl website for manufacturer information.
